Electronics Forum | Wed Aug 03 20:54:06 EDT 2011 | dekhead
The "low line" DEKs are made in China now (same ones marketed in China under the ICON nameplate)... Higher level are still made in UK... I thinkk similar with MPM; I know they are still producing machines in Mass... Both suffer from cost down manufa
Electronics Forum | Tue Aug 16 17:33:13 EDT 2011 | rway
I doubt that will do anything. You have had the board powered down and powered back up, right? This will have the same effect. But hay, what have you got to loose?
Electronics Forum | Wed Aug 17 17:24:42 EDT 2011 | bobbydur
Yes I have powered the board up and down many times and yes I have tried a different battery. This board should be able to work with no battery. I think I will have to pay for it to be fixed or find a replacement Many thanks
Electronics Forum | Thu Aug 18 17:17:15 EDT 2011 | jlawson
Rehm is good choice...uses higher grade materials and electrical parts , especially blowers (3 Phase), not the China Made blowers as use in Heller. Most perople complain about blower failure on Heller... which is a cost in blowers but more issue of
Electronics Forum | Thu Sep 22 20:52:08 EDT 2011 | dekhead
Low DCV on batteries should not cause issue with MINT download, but will cause loss of MINT files (and necessitate reload) upon power down... Please contact me for additional assistance. http://www.dekhead.com
Electronics Forum | Fri Nov 04 21:57:37 EDT 2011 | machinehead
When I'm Tearing down a Job, And removing the tape and reel from Agilis Feeder. Their is a gap of at least 10-12 Parts. Unpicked parts, When the knife on the feeder spreads the tape aside. and leaves this gap of feel falling parts.
Electronics Forum | Fri Oct 28 13:27:58 EDT 2011 | kmakiya
Check to see if the mount precision is set to high in the package acceleration field. We set this to normal and the oscillation went away. I wonder if slowing down the x-axis would help.
Electronics Forum | Mon Oct 31 02:36:01 EDT 2011 | kenmar
Thanks , If you reduce the placement precision the X-Axis does not make any noise but than I had placement /pickup problems when it comes to Ic's.Slowing down did not make any difference.
Electronics Forum | Fri Nov 04 16:36:53 EDT 2011 | davef
tombstonesmt: Ammonia based masks can create solderability issues after they are removed. You can get non-ammonia based latex mask material but down side is slower cure and cost a little more as they have higher levels of latex etc
Electronics Forum | Tue Nov 22 05:44:05 EST 2011 | bobpan
I thought the the machine was slowed down to speed setting 1 for the x/y axis and the machine worked. I think the x-motor was on its way out.
