Electronics Forum | Wed Jun 14 15:17:15 EDT 2006 | Chunks
We too have run different pastes and found similar results. I do not repsond to this post to help the Doctor out.
Electronics Forum | Sat Jun 10 18:55:12 EDT 2006 | G Eisner
i have pictures available now so if you want send me an email at geisner@pacificinsight.com Thanks
Electronics Forum | Fri Jun 09 21:33:30 EDT 2006 | Professor Besserwisser Dr Dr PhD
I think You should try to do the Delta X test, because there is a mine somewhere in the universe that has the bahodium who take care of all of this. Hahahaha I couldn't resist.
Electronics Forum | Fri Jun 09 21:53:07 EDT 2006 | Professor Besserwisser Dr Dr PhD
I am sorry, but I hope No hard feelings? :) As for an answer to Your question: No I can not see the reason for using three heat zones on the wave. Anybody else?
Electronics Forum | Mon Jun 12 10:34:06 EDT 2006 | cuculi54986@yahoo.com
My brother-in-law is a DDS and I trust him. We had some problems with solder voids in the past, and he was invaluable. He'd drill them out and fill them with SAC3240X+.
Electronics Forum | Mon Jun 12 10:46:38 EDT 2006 | Chunks
It's hard to believe MoonMan spends this much time typing these rants. Guess the boys at ever so much higher I.Q. standard of engineering, IPC, kicked him out there too.
Electronics Forum | Tue Jun 13 08:49:34 EDT 2006 | russ
Your new problem is inadequate flux coverage. This may be a contributer as well to the BNC issue. Russ
Electronics Forum | Sun Jun 18 04:08:32 EDT 2006 | anilw2006
I am looking for fuji fcp6 machine .but my worry is i can use cp6 for glue procrss? Regards, Anil Wagh.
Electronics Forum | Mon Jun 19 09:31:15 EDT 2006 | vikkaraja
What are you trying to do? If you provide us with a little more information, you might be able to get some better response.
Electronics Forum | Mon Jun 19 14:04:39 EDT 2006 | slthomas
Because some lead free solders are very corrosive to anything but titanium. Also "clean it very well" is kind of a crap shoot, isn't it? Did you get your solder tested for impurities and lead %age after you did the swap?