Electronics Forum | Thu Jul 16 19:32:23 EDT 2009 | fujiphil
Hi, I am from the Philippines, is it ok for you? I'm currently working as field service engr in our territory. Rgds...
Electronics Forum | Thu Jul 16 10:52:34 EDT 2009 | desrtscrp
Lost hard drive and backup software for our pre 2000 Cyberscan Cobra 2D Laser Profile Scanner. If anyone out there could help me find a copy for purchase I sure would appreciate it! Thanks!
Electronics Forum | Thu Jul 16 22:03:46 EDT 2009 | azhiker
Hello, We have a DEK 265 we will run our boards front justified with relation to the stencil, can anybody give me an offset that you are using to order your stencil when the image is in the front? Thanks
Electronics Forum | Fri Jul 17 07:13:23 EDT 2009 | thanhnguyen
just tell the stencil house, have it cut at center of front stencil. how about your DEK with auto stencil loading of manualy pull rod???
Electronics Forum | Fri Jul 17 09:12:00 EDT 2009 | azhiker
thanh, It has a pullrod. I will order the stencil as you suggested, center and I'll just offset it with the pullrod. Thanks for your input!
Electronics Forum | Fri Jul 17 12:07:14 EDT 2009 | azhiker
See attachment. Hope it is useful. DucHoang, Thanks for the info. This is exactly what I was loking for, since I didn't have a DEK manual with me. Thanks a lot!
Electronics Forum | Fri Jul 24 02:57:05 EDT 2009 | fede
I use Center Edge, and adjust stencil offset. It's very easy, you just have to give it the PCBs width. An other advantage is that If your PCB has scrap strips, and you lose them, or PCB changes, you can print it anyway.
Electronics Forum | Sat Jul 25 21:18:57 EDT 2009 | mika
Why are you using front edge justification? We have never used anything but centre justification. How big are your boards and where are the "image"? In the respect of the Boards?
Electronics Forum | Fri Jul 17 04:24:35 EDT 2009 | floydf
We are getting an ESD epoxy floor in our plant. Could someone recomend a mat that would protect the floor from solder spills by the wave solder.
Electronics Forum | Mon Jul 20 06:10:32 EDT 2009 | thanhnguyen
BTU ( VIP70A) lid will not close, during the weekend, we pop up to clean and vaccum, after done, try to close the lid, but not work. any input will be helpful. thanks