Electronics Forum | Fri Jun 04 11:38:47 EDT 2021 | bangir
Hi All, Do you have any experience for LGA component rework on SRT equipment? Please share how to re-soldering the LGA component to PCB pads. Thanks
Electronics Forum | Fri Jun 04 17:47:34 EDT 2021 | pjchonis
Thank you very much for your insights! I appreciate your time.
Electronics Forum | Wed Jun 09 23:58:59 EDT 2021 | SMTA-64387687
The electrical test, on those older machines, wasn't very exact. Try to expand the tolerances, 25-30% for caps and 10% for resistors, and see if that solves your problem. Also, if I remember correctly, if you go into the layout and single-place the c
Electronics Forum | Thu Jun 10 16:40:48 EDT 2021 | cyber_wolf
Yes those verifiers seem like a good idea but they really don't work correctly. You would be better off verifying with a meter during reel changes than wasting your life on that thing. I concur that single mount will show the value.
Electronics Forum | Sat Jun 12 05:54:53 EDT 2021 | starsanat
Hello dear users I got this message on machine: "ALARM occurred in WIDTH axis". How can I fix the problem if anybody has this before
Electronics Forum | Wed Jun 16 08:55:08 EDT 2021 | bukas
have you checked how is oven configured in oven setup wizard? if you run it now you should be able to see current config. make sure you backup old config before making any changes.
Electronics Forum | Wed Jun 16 10:02:58 EDT 2021 | shmevan91
Yes this has been checked, had to change them to manual in order to manually adjust the rail width by hand by turning the chain.
Electronics Forum | Wed Jun 16 10:04:25 EDT 2021 | shmevan91
Rail width won't move at all, tried a motor from another oven to rule that out but still no joy
Electronics Forum | Wed Jun 16 10:35:28 EDT 2021 | bukas
did it work before? have you checked all position/home switches and sensors?
Electronics Forum | Wed Jun 16 11:12:12 EDT 2021 | shmevan91
Hi, Yes was all working until factory was shut for a week and then when powering back up it would not move, all sensors have been checked and working as they should, everything has been checked to make sure its not jammed/stuck.