Electronics Forum | Mon Apr 11 08:39:41 EDT 2005 | Grant
Hi, Yes, it's going to be hard. I was thinking a high end fine pitch placer could place the fine pitch accurately, and then slowly do the passives. That might do the trick, but unless he's prepared to spend at least half a million, it's going to jus
Electronics Forum | Thu Apr 07 10:39:36 EDT 2005 | geb
I have a BTU International VIP98 reflow oven, running WINCON Version 2.00C on Windows 98. The light tower only lights green when the oven reaches temperature, and the other colours never light up. Do you know how to set the other colour lights to tu
Electronics Forum | Thu Apr 07 10:58:01 EDT 2005 | Dhanish
Need help from the experts on 1)simple way to measure the PCB warpage 2)what is the maximum warpage can the SMT machine allow the to accept and place the component without problem. 3)I have seen some people are using 7mils/inch as a Warpage spec. a
Electronics Forum | Fri Apr 08 17:23:34 EDT 2005 | KEN
Warpage factors can cause: 1. Boards can not transfer down conveyor belts or wedge at transitions. 2. May not enter into machinery due to interferences (like board clamps) 3. May fall off conveyor chain in furnace. Especially true of thin (PCMCI
Electronics Forum | Thu Apr 07 19:30:09 EDT 2005 | chrispy1963
Hi there To all the MyData users out there who use Agilis feeders I would like to pose a question. What does your company do with the feeder sticks you have that get the tips of the plows broken off? Do you get them repaired or do you toss them aw
Electronics Forum | Fri Apr 08 13:55:05 EDT 2005 | chrispy1963
Grant, Yes they do get broken by the operator or whom ever is loading or unloading the feeder stick pulling the tape through the feeder and the component pocket will snag the tip of the plow and bend it so that the tip ends up breaking off making
Electronics Forum | Fri Apr 08 12:03:31 EDT 2005 | mmjm_1099
Here we go again..... check all past forums on Lead-Free. There is a TON of stuff that people has talked and commented on for this. Plus a good site for alot of information I found is: http://www.speedlinetech.com/news_publications/white-papers.aspx
Electronics Forum | Sat Apr 09 18:33:08 EDT 2005 | valuems
Hello If mr. Miller will go to the dos promp ( esc key ) and type in dir/w and then open the .000 file he will find the pass words. As far as the UP100 goes, god only knows. Forget finding this in the manuals. And I should add the .000 file is a su
Electronics Forum | Mon Apr 11 06:37:59 EDT 2005 | amstech
As long as you have a continuous profile with required soak and dwell periods, the zone lengths do not matter. For lead free, usually ramp to peak is preffered.that is with minimum soak (you can not avoid soak anyway. You can achieve the profiles irr
Electronics Forum | Tue Apr 12 22:23:05 EDT 2005 | Al
The way we do this, is to tape a transparent film to the PCB. The printers and chip shooters can read fiducials no problems. Once it has been run through SMT, simply remove the tranparency film and the PCB is ready for use, no mess no cleaning and yo