Electronics Forum | Thu Dec 03 15:34:57 EST 2015 | proceng1
Superior 420-XF-LF is what we use. When we switched, it took some time of just running it through the stone before we got the optimal performance. Especially when going into the clean and dry tank on monday morning, we usually let the fluxer run for
Electronics Forum | Sat Nov 07 22:00:29 EST 2015 | ttheis
I've seen a few used machinery companies using manual smema interface boxes with a few buttons on them to simulate upline and downline equipment but I haven't found anyone selling them or info on them. Does anyone know where they can be bought or if
Electronics Forum | Tue Nov 10 00:18:52 EST 2015 | ttheis
How is a board conveyor typically configured to unload into a conveyor oven if there is no downline machine to five a ready to receive signal? Do you just use a plc to activate the machine ready signal at a timed interval? Would you perhaps do the sa
Electronics Forum | Tue Dec 29 11:38:40 EST 2015 | g2garyg2
Hi Tom If the DYNAPACE has SMEMA out all you need to do is place a two wire jumper into pins 3&4 or 1&2 depending upon DYNAPACE's SMEMA configuration. This will by-pass a Release signal and feed PCBs into the oven.
Electronics Forum | Thu Nov 12 10:16:25 EST 2015 | goodting
Good day. I am asking if anyone knows how to access/have a copy of our BIOS file. This BIOS file which was designed by Phoenix , called biosrec.zip. Each day, we used the main EPC-1316(PCA,CPU/PMC)card to boot our Advantis machine; but the speciali
Electronics Forum | Mon Nov 16 20:22:52 EST 2015 | billthebuilder
I need one for testing a PnP machine. It's very hard to hunt something down just by package, so does anyone know of anything with a 0.3mm pitch? BGA preferred. Or clues where to look? Thanks!
Electronics Forum | Sun Jan 03 04:26:36 EST 2016 | sarkhosh
Hi Dear sir I have a question,My F5HM machine have mc hdd problem and dosen't boot. would you please let me know where can I download or find the mc installer floppy. with regards Masih Email: sarkhoshm@gmail.com
Electronics Forum | Tue Nov 17 14:48:41 EST 2015 | jpal
I have to figure out how to install a two-pin JST through-hole connector. It is a press-in style. We have pressed in larger connectors on single-sided boards with our pneumatic machine but this is a small connector on a double-sided board with small
Electronics Forum | Thu Nov 19 21:34:09 EST 2015 | ttheis
We just powered up a used GSM1 for the first time and it seems to boot and initalize ok. It is running UPS 3.2.2c. The first thing we noticed upon initial power up is that there is a lot of 'noise' on the monitors. Is this normal due to being designe
Electronics Forum | Sun Nov 22 18:03:38 EST 2015 | ttheis
Hi Deni- Thanks for the reply. I'll try to figure out what vision system is on it. I know it has two 5.3mil cameras front and back, UPS 3.2.2c os/2. Where do I determine the type of vision system; in the computer or harware spec plate?