Electronics Forum | Tue Mar 22 14:50:11 EDT 2016 | ttheis
A friend of mine has a used gsm1 but when loading up UPS it gives an error indicating it did not receive a request to load the machine model in the allotted time. Photo is attached of the message. Any suggestions what to look at? The machine is runni
Electronics Forum | Wed Mar 23 20:13:19 EDT 2016 | ttheis
UPDATE: For anyone experiencing similar issues it looks like it is bad axis control card(s.) It would make sense since that is what the message said... A red "fail" led was overlooked on one of the cards apparently. I had this same issue with anothe
Electronics Forum | Wed Apr 13 03:20:19 EDT 2016 | smtsparescn
Actually SMT mounter's vision system is similar as the AOI machines,it judges the right or wrong based on: 1.the black and white identification 2.it's measurements 3. the comparison between it's measurements and the input data There is a tolerance o
Electronics Forum | Wed Mar 30 11:59:56 EDT 2016 | cbeneat
Our company has 8 EKRA X5-X5 Pro's we do not use that function on any. Personal preference I guess. I assume the cartridges are set up like the pneumatic gun type dispensers, drop in a cartridge and go. Not in Europe, sorry no knowledge of where t
Electronics Forum | Thu Apr 07 17:29:29 EDT 2016 | curiousman
Program and then the send button which brings me to a blank screen which I assume shows a log of what it is sending. It is blank however. I am wondering if there is something I am missing that needs to be done to transfer the program over. Anyone h
Electronics Forum | Wed Nov 30 03:42:42 EST 2016 | bukas
i have a SPA 250, it has serial connector but uses RS485. only 2 pins of serial connector are in use. it is very likely that this is the case with SPA 400. there are some settings in offline editor, if you havent fixed it yet i can send you some pict
Electronics Forum | Tue Apr 19 10:09:33 EDT 2016 | swag
Try a nozzle changer teach. Machine will look for fids on the changer block. If that doesn't work, clean the rubber seals in the bottom of the block. No alcohol - dries them out. Might need to replace them if they are dry or cracked. Clean your
Electronics Forum | Tue Apr 19 07:23:39 EDT 2016 | clockwatcher
For ESD control in the factory we use foot & wrist straps, and ESD smocks. We also have ESD work surfaces including ESD flooring throughout the plant. We have been using ESD chairs and now the question has come up on if and how often these chairs nee
Electronics Forum | Fri May 06 17:03:03 EDT 2016 | ttheis
A similar issue happened with our second machine the other day. I noticed on both machines that the "BM" light on the sys68k cpu force board goes out when this happens. Does anyone have any insight on what this means?
Electronics Forum | Fri May 06 20:22:02 EDT 2016 | ttheis
I found this in the Force SYS68K CPU-30 manual: ------------ "BM" LED If the CPU board is the current VMEbus master, the green BM LED is lit. This provides the user with a convenient visual indication of the status of the VMEbus. ------------ So th