Electronics Forum | Wed Oct 25 11:25:12 EDT 2017 | paddyronan
Hi all, I have a recent issue with an IP3 machine. The machine cycles through normal power up routine. Then the video monitor and VME card shit themselves down and after a couple of minutes the CPU board powers down. However this is intermittent. Wh
Electronics Forum | Thu Oct 26 12:14:34 EDT 2017 | lefwan
Our DEK 265 machine is showing this error message during starting…than it keeps re-starting in endless loops: Diskette drive failure on drive A Fixed Disk Controller Failure Fast ready check - Version 1.0 Copyright Arcom Control Systems Ltd. CMOS
Electronics Forum | Wed Nov 01 11:51:13 EDT 2017 | spoiltforchoice
I don't think you will find any of that out there and freely available. As I recall MyData was one of those manufacturers who insist you do their training at their facility which limits the ability for the material to escape into the wild. I would su
Electronics Forum | Thu Mar 08 07:24:40 EST 2018 | proceng1
That's what I said when we started talking about 48inch boards. Everything changes. New printer, bigger stencils, new pick & place. Different even profiling (the board is in 3 zones at the same time). Plus board racks don't work well. The old Boa
Electronics Forum | Mon Nov 06 21:02:45 EST 2017 | dlerkin
Hi, I'm looking for a software copy for the CyberOptics Cyberscan Cobra Laser Profile Scanner. An issue with one of the files is preventing the software from running and we no longer have the original copy to re-install it on our computer. This Cyber
Electronics Forum | Tue Nov 07 08:10:54 EST 2017 | smtpatrick
I have a number of nozzles for an Assembléon AX-201 that have been allowed to become clogged with old, dried-out solder paste. I am thinking of using an ultrasonic tank in an attempt to clean them for re-use, but I am concerned that isopropyl alcoho
Electronics Forum | Mon Nov 13 09:40:01 EST 2017 | philc
Just a few thoughts, as we use similar quite frequently without issues. Ensure correct support when pasting the board, especially if it is thin. Correct support when placing the part. Is it placed correctly by the machine? If it is very slightly of
Electronics Forum | Fri Dec 01 12:56:33 EST 2017 | emeto
It seems that it will work with 5 mil stencil. To be safe use 4 mil if the rest of the design allows it. 10x20mil apertures for both rows. If you have bigger footprint in the corners, make bigger apertures there. For the ground plane, I would use ver
Electronics Forum | Sat Dec 02 10:23:47 EST 2017 | tomh
Have you ever heard of "Solder Mask Defined Thermal Pads"? I wrote a short blurb on this here - https://www.pcblibraries.com/forum/ipc7093a-btc-qfn-solder-mask-defined-thermal-pad_topic2154.html This technology saves fabrication costs by not havi
Electronics Forum | Mon Dec 04 08:43:39 EST 2017 | bandjwet
If you are looking to rework (after all of the previous suggestions are taken and tried....you have some solid ones in there). When a device like this is placed and is hard to get to we use the 7721 bumping process using a controlled heat source (no