Electronics Forum | Tue Nov 20 00:15:41 EST 2018 | sabeti
Hi Everybody, We have a dek 265 LT screen printer which unable to detect the plate. I think that it might be the light barrier sensor with the part number of 13pl14. I cannot find a new sensor so I thought I can use a jumper to connect the black wir
Electronics Forum | Thu Nov 22 23:46:27 EST 2018 | jaypark
Some PTHs on a board in the product I am building are not filled enough to meet the IPC-610-F requirement(at least 75% vertical fill) . I have no access to the solder source side due to something installed right beneath it. In order to completely
Electronics Forum | Fri Nov 30 12:21:26 EST 2018 | davef
Three things ... 1. Since you are soldering a component over a hole that limits the possibility that the hole could be filled with solder, it makes me wonder if the hole is supposed to be filled with solder. What do the engineering notes say? 2. Ta
Electronics Forum | Mon Nov 26 11:41:34 EST 2018 | tey422
Anybody is familiar with ePM-SPI software? All the ones who trained are left the company, and there is no notes nor manual left behind which I can look up to learn it. Are there manual available for sharing or useful training material for the ePM-S
Electronics Forum | Wed Nov 28 21:37:53 EST 2018 | lukejk95
Hello, so basically I've been having trouble with parts popping up as they are being inserted into the PCB. It happens at random and I've gone through multiple rebuilds and tons of adjustments and still cant get a clean run. I've tried raising the cu
Electronics Forum | Thu Nov 29 12:28:32 EST 2018 | slthomas
What I'm thinking is that your cutter/former (or whatever the "boot" shaped assembly is called, that provides the dies for cutting and forming parts from the tape) could be worn, dull, bent, etc., and once in a while you get a lead that doesn't enter
Electronics Forum | Tue Dec 04 02:32:38 EST 2018 | ameenullakhan
Hi, Thanks for the valuable feedback. Agree with you. 1. We have similar component on both the side of the board. 2. The component fall was random like 4 out of 100 components.But last build it has increased. 3. Applying glue dot is option , bu
Electronics Forum | Mon Dec 03 08:25:29 EST 2018 | proceng1
I have a Heller 1808 Reflow oven with the chain that has the edge hold to keep the boards off of the mesh belt. The feed end was more narrow than the exit end, and some boards would fall off. So we adjusted both ends to be the same. Well now, when
Electronics Forum | Mon Dec 03 14:49:23 EST 2018 | dleeper
Are they getting stuck inside the oven or at the very end? If thermal expansion is the problem the boards would be getting stuck in the reflow zone since that would be the hottest and therefore the point where thermal expansion would be the greatest
Electronics Forum | Mon Dec 03 18:30:29 EST 2018 | slthomas
Not sure how the lead screw drive gear is locked in place but is it possible that it's slipping in both directions (when driving the rail both forward and backward) and then not catching until after the other end has already moved some? You could h