Electronics Forum | Fri Jun 25 15:39:57 EDT 2010 | tate350
I'd wash them first then AOI. Especially you use the same AOI for WS and no-clean. You certainly will not want any WS flux left inside teh AOI then use the AOI for a NC PCB...
Electronics Forum | Thu Jun 10 07:44:41 EDT 2010 | jdengler
Did the machine work when you first installed it? Have you done a reset start yet? Make sure you have air applied when you power up. The IP's don't like to power up without the air.
Electronics Forum | Fri Jun 11 16:19:04 EDT 2010 | bandjwet
Does anyone have good/bad experiences with tacky fluxes for rework? Which vendor/formula should I start with? Which ones should I stay away from? Thanks! BWET
Electronics Forum | Wed Jun 16 15:39:15 EDT 2010 | mikesewell
Keep in mind you'll still need to preheat the assembly to properly activate the flux/drive off volatiles in the paste. Perhaps a convection toaster oven... Add some cooling coils and a freeboard/tube to the top of your pasta cooker or turkey fryer t
Electronics Forum | Mon Jun 14 17:18:10 EDT 2010 | sumote
Has anyone had to do any work with circuit cards that are exported to satisfy the REACH or SVHC restrictions? I am looking for a consultation service in the US that can assist with starting a program. Any help or leads would be appreciated. Thank yo
Electronics Forum | Sat Jun 19 11:16:29 EDT 2010 | rajeshwara
hi I am Customer Support engineer for Alpha Metals.Attached is the doc , plz go through that.
Electronics Forum | Thu Jul 01 07:31:59 EDT 2010 | muarty
Hi Tim, I would speak to your guys at Indium, as I am sure they have a paste developed primarily for Conformally Coated products which should alleviate your problems. John
Electronics Forum | Fri Jul 23 03:25:43 EDT 2010 | cobar
Please wash the PCB`s before conformal coating.Do you use deodrant before or after you shower??????
Electronics Forum | Mon Jul 26 16:28:49 EDT 2010 | mikesewell
Beyond just the cosmetic dewets reliability is very flux/coating dependent. Don't forget about any touchup or hand soldered parts after wave as well.
Electronics Forum | Wed Jun 16 16:49:16 EDT 2010 | nguyennca
I have an error that stop FIP 3 from running. The error is "FIP OSS2 R3.1Bi CRTA event I/O. If anyone knows what this error is about then please help. Thanks
Manufacturer of PCB depaneling and PCB soldering machines since 2005, products include CE approval V-groove PCB depanelizer, PCB router, PCB punching machine, laser depaneling, hot bar soldering machines and soldering robots.
Liwu Industrial Park, Yuanzhou Town, Boluo
Huizhou, 30 China
Phone: +86-138-29839112