Electronics Forum | Thu Apr 10 14:35:18 EDT 2003 | russ
What flux are you using to put them back on? you should be able to adequately clean the site after removal with alcohol or water depending upon the type of flux. "White grungy" usually comes from a liquid flux such as Alpha 857 being squirted on th
Electronics Forum | Fri Apr 11 12:45:23 EDT 2003 | jonfox
Assembleon Topaz (many different flavors) or you can pick up an almost new Universal GSM pretty cheap these days. Are you looking for "new" equipment only? What are your requirements and/or features you are looking at/for? Another good machine if
Electronics Forum | Fri Apr 11 16:11:32 EDT 2003 | stefwitt
The question new or used was discussed several times. If you start fresh and have no experience with one or the other machine vendor, I would get a new machine, whose supplier has a service tech in driving distance. If you select the used machine pa
Electronics Forum | Mon Apr 14 12:33:14 EDT 2003 | Brian W.
In many cases, if you buy a used machine, it is worth the investment to register your machine with the manufacturer. That way you have access to support and information for your machine. A number of the machine manufacturers also refurbish their eq
Electronics Forum | Wed Apr 16 21:00:50 EDT 2003 | yukim
Hi Dave, thanks! The peak temp on the terminal device is about 210C. Some more questions: The soldering part of the terminal is about the same size as the PCB pad. We observe a lot of voids when we remove the terminal device, whice can be removed v
Electronics Forum | Mon Apr 14 10:20:05 EDT 2003 | davef
Daan Terstegge, on his excellent site [ http://www.smtinfo.net ], makes several free DFM checklists available for download. Earl Moon contributed couple of them. Moonie has been a generous contributor to the SMTnet Forum and wrote several knowledge
Electronics Forum | Wed Apr 30 08:00:33 EDT 2003 | pjc
Jason, In Transmission AXI the entire solder joint volume is imaged, not just a slice (no missing information) as with Cross-Section. Also, there is no signal loss from mechanical or digital image reconstruction (highest contrast and edge strength).
Electronics Forum | Mon Apr 14 22:59:18 EDT 2003 | mantis
We Operate a procedure were by all potenial employes who are likely to be exposed to lead are screened for lead content in there blood prior to hiring,and once every year there after.There is no compensation given as this is mandatory but it is also
Electronics Forum | Mon May 17 15:14:12 EDT 2004 | solderpro
Agree with Joe 100%, we recently brought one in from Malcolm for trial, this company had not practiced viscosity reading or anything in the process, the trail run was a great improvement in print, consistancy, deposition and formation of the solder b
Electronics Forum | Wed Apr 23 07:46:49 EDT 2003 | pbc1963
Bernard, The problem we have is when unloading the feeder several components may be lost due to the partial peel back of he cover tape. This area I am referencing just passed the point of the knife to the pick area. Also matching the correct feeder
Manufacturer of PCB depaneling and PCB soldering machines since 2005, products include CE approval V-groove PCB depanelizer, PCB router, PCB punching machine, laser depaneling, hot bar soldering machines and soldering robots.
Liwu Industrial Park, Yuanzhou Town, Boluo
Huizhou, 30 China
Phone: +86-138-29839112