Electronics Forum | Fri Jun 24 04:42:12 EDT 2005 | ajaydoshi
We do have BTU 150 Paragon. What the practical air setting for all 10 zones + 2 coolig zone. This setting is to manually adjust on machine front right botton side. ajay
Electronics Forum | Sat Jun 25 19:35:31 EDT 2005 | Mike Konrad
The Kenco ionic contamination tester (Zero-Ion) is now manufactured and supported by Aqueous Technologies. www.aqueoustech.com service@aqueoustech.com (909) 944-7771 Mike Konrad
Electronics Forum | Tue Jun 28 06:17:16 EDT 2005 | bobpan
I have had an old hard drive causing the same type of problem and until i installed a new hard drive the speed was sssssslllllllooooooowwwwwwww.
Electronics Forum | Mon Jun 27 16:53:43 EDT 2005 | davef
We've talked about this previously. Search the fine SMTnet Archives for additional background. For instance: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=30307)
Electronics Forum | Sat Jun 25 10:04:08 EDT 2005 | ktron
Hi MSK, Stencil thickness: 5mils with laser cut Smallest pitch: 20mils Underscreen cleaning frequency: 10 bds per cleaning Note: We have decreased the cleaning frequency from 10 boards to 3 bds to reduce solder bridging after printing Regards,
Electronics Forum | Sun Jun 26 22:56:13 EDT 2005 | vera1001
hello everyone,i have not visit smtnet.com so long,are you ok?vera http://www.hkenterprise.com/szcomfaje vera@comofaje.com
Electronics Forum | Mon Jun 27 11:06:20 EDT 2005 | geb
Do you know why my solder paste sticks to the squeegee so much that it mis-prints and how can I prevent it from happening. I can only get about 3/4 prints before this happens.
Electronics Forum | Mon Jun 27 11:24:03 EDT 2005 | russ
What size paste roll do you have on your stencil? It should be about 1/2" in diameter. What type of paste are you using? I have found that certain Mfgrs have this problem with some of their formulations. What typoe of printer and what is your squ
Electronics Forum | Mon Jun 27 11:32:45 EDT 2005 | sumote
Humidity level can play into this as well. Good blades will help the process. We use permalex blades from Transition Automation and we love them. YMMV
Electronics Forum | Mon Jun 27 14:09:25 EDT 2005 | davef
We've talked about this previously on SMTnet. Try searching the fine Archives. For instance: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=5473
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, CA USA
Phone: 18002796835