Electronics Forum | Thu Mar 16 11:27:52 EST 2006 | Jschafer
We have 3 Omron machines here. Of those, we have 2 that are desktop. I would also recommend using teh pixel counting machine over teh pattern matching one. It is easy to program and very repeatable. You can inspect as much or as little as you cho
Electronics Forum | Thu Mar 16 11:29:07 EST 2006 | Jschafer
We have 3 Omron machines here. Of those, we have 2 that are desktop. I would also recommend using teh pixel counting machine over teh pattern matching one. It is easy to program and very repeatable. You can inspect as much or as little as you cho
Electronics Forum | Wed Jan 18 07:48:12 EST 2006 | avalancher
Hi Ron, The Tray Wagon magazine is designed to go on all the MYDATA machine types, and equipped options. When you have a conveyor system, you do need to mount it so that when the tray wagon goes all the way to the back, it does not hit the exte
Electronics Forum | Wed Jan 18 09:06:30 EST 2006 | ronhammer
What I mean by it does not work is after I moved the brackets I have about 4.5 inches from the end of the TWM to the conveyor point. None of our conveyers fit there all our Conveyers have about 6 inches in the front on the conveyer. Is there a differ
Electronics Forum | Wed Jan 18 08:34:09 EST 2006 | Nathan
We are designing a new in-line inpsection station for PCBAs and I am a little confused about how to interpret two the Mech. Interface standards in SMEMA 1.2 (items 5 and 6). What is exactly meant by "maximum gap"? Does this get at the distance betw
Electronics Forum | Wed Jan 18 16:30:30 EST 2006 | davef
380SR-flux gel is sold by Cobar. Look here: http://www.lumileds.com/pdfs/AB10.PDF This application note suggests: * �#1;Metals 390DH4 * �#1;Metals LR735 * �#1;Metals NS4029 * ESP 6#1;412 * Cobar 380SR#1;flux gel Comments are: * "�#1;Metals" is "A
Electronics Forum | Thu Jan 19 06:39:56 EST 2006 | dougs
It's been a few years since i worked on a CP machine but your st17 & 19 errors are probably down to grease in the clutches at the top of the shafts, if too much grease is put onto the turret gear during maintenance it tends to spray into these clutch
Electronics Forum | Sat Jan 21 19:44:07 EST 2006 | vincent
i have a problem similar to Daxman where cp6 usually having problem when it run at high speed, the head seems to have problem returning back to its origin at st12 and stop at st15 and st19 for nozzle change error, when rotating the head by hand, some
Electronics Forum | Wed Mar 29 08:14:14 EST 2006 | cyber_wolf
Dax, You need to clean out those clutches. Even if they seem OK they can still get varnished up and cause minute alignment problems. I think I mentioned before that you can get in there with a Q-tip, but the true way to get them perfect is to take t
Electronics Forum | Fri Mar 31 16:02:35 EST 2006 | daxman
I'm not sure if we are on the same page here....maybe i'm lost in the terminology. We are pulling the entire placing head. The Windmill, the shaft, the clutches...the entire thing. I'm not sure if this is what you mean by, "dropping the clutches"
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, CA USA
Phone: 18002796835