Electronics Forum | Tue Sep 16 09:39:33 EDT 2014 | emeto
Hi there, It looks weird how you handled the problem. Just a thought, but would you check the stencil and may be recut a new one, making sure you have the image exactly in the center and have the fiducials exactly where you want them and the frame
Electronics Forum | Fri Aug 28 11:59:05 EDT 2015 | gascon5383
Actually I should have noted we resolved this issue. After chasing our tails for a while, we found that somehow there was a static charge on the boards going into the machine. This static was discharging to the camera through the board stop, causing
Electronics Forum | Mon Sep 08 16:49:28 EDT 2014 | jorge_quijano
I'm about to start a project to install some controls on our tooling for production, such, stencil, fixtures, feeders, press-fit tools, WS pallets, etc... How do you deal with that? I know there are some software solutions that may work, but what act
Electronics Forum | Tue Sep 09 10:02:47 EDT 2014 | cyber_wolf
Just so you know, it is completely normal to whack the leveling feet of brand new machines with a 3lb ball peen hammer to adjust the machine in the line. The machine was moved several inches using this method. Brand new 180K+ machine. Factory FSE wa
Electronics Forum | Fri Sep 12 06:53:32 EDT 2014 | spoiltforchoice
Surely this depends on the scenario? Quite a few manufacturers feeders use spring contacts http://www.harwin.com/product-search/P20-0/ perhaps a bit like these, so your PCB would simply have pads to align with those contacts. Of course this relies o
Electronics Forum | Fri Sep 26 16:02:28 EDT 2014 | heath
Hello all, I'm curious to hear how successful others have been with vibration feeders on their pick and place machines. We have a MY12 and a major source of consternation comes from parts not shaking down to where they can be picked up. The variab
Electronics Forum | Sat Sep 27 19:47:21 EDT 2014 | cyle
Reels are 100% the best, vibration feeders should always be a back up, they are quite unreliable through no fault of their own. Say you have 1000 parts to be placed, and the cost of a reel is 100$ more than a tube, but the reel loads 10 to 1 over th
Electronics Forum | Sat Sep 27 21:44:12 EDT 2014 | isd_jwendell
A rejected part from a reel is a little bit of a pain to use, where a rejected part from a tube is easy. That doesn't mean that I like tubes though. I have also found that some parts cost more when delivered on tape. First check that your machine is
Electronics Forum | Mon Sep 29 18:37:22 EDT 2014 | spoiltforchoice
Don't know if you can do it on a MyData, but I have found that I lower the rate of failed pickups on our machine by altering the placement order of devices. Specifically insisting it does not attempt to pick sequential parts from the same lane. Of co
Electronics Forum | Sat Sep 27 13:12:37 EDT 2014 | gascon5383
I have a situation and was hoping to get some opinions on whether a saddle type profile is better or worse than a linear profile. We have an 8 heating zone 3 peak zone and 4 cooling zone single track oven that I am having a tombstone issue with. It's
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, CA USA
Phone: 18002796835
