Electronics Forum | Thu Jan 14 16:32:58 EST 1999 | Dave Jurena
Hi all, I thought I'd use this forum to ask a couple general questions on fluxes for manual operations: First - Is it OK to use a wave soldering type flux (specifically OA)? Thinking about activation temperatures and the ramp rate of the wave solder
Electronics Forum | Thu Jan 14 15:29:16 EST 1999 | JMC
You pretty much hit the nail on the head Chrys. Reed runs a lot of exhibitions for a lot of different industries, and they do very well for themselves, probably too well. Right after InterNepcon Japan '96, the major equipment suppliers in Japan got
Electronics Forum | Thu Jan 14 08:32:22 EST 1999 | Jim Nunns
They are supposed to be production parts. Our volumes are in the hundreds due to rapid change though. Jim Nunns | Just a comment: we've seen PBGAs curl up at the corners, but only on prototype components that came off of a low-volume "prototype"
Electronics Forum | Wed Jan 13 07:37:45 EST 1999 | EFData
We have evaluated using WS-629 and our feelings are that the formula is not very stable. One evaluation showed great results; superior solder joint appearance and good printability. The paste would not roll on another evaluation nor would it release
Electronics Forum | Wed Jan 13 21:46:03 EST 1999 | Dave F
| I am currently using Alpha WS629. I have a Malcom SPS-1 Solder paste mixer. I find that the mixer after running for the recommended mixing time | (10 to 18 Min) ball's the solder in the jar. | | 1) Is there any other Manufacture having the same
Electronics Forum | Tue Jan 12 19:49:28 EST 1999 | Ross Berntson
| Hi Folks. Has any Process Engineer here done a complete evaluation or controlled experiment for VOC-FREE Flux? Our goal here at CEBUKid, Inc. is to implement a VOC-FREE process. We have all the necessary (OPTIFLUX) spray equipment, and we're cur
Electronics Forum | Tue Jan 12 17:03:59 EST 1999 | Ryan Jennens
How is everybody? I was asked about any problems that would be associated with having a plastic casing injection molded around an assembled PCB. I am not sure if injection molded plastic has to be hot, I am assuming so (can they use epoxies?).
Electronics Forum | Wed Jan 13 15:43:00 EST 1999 | Dave F
| How is everybody? | | I was asked about any problems that would be associated with having a plastic casing injection molded around an assembled PCB. I am not sure if injection molded plastic has to be hot, I am assuming so (can they use epoxi
Electronics Forum | Tue Jan 12 16:16:21 EST 1999 | Sanjay Bhatikar
For process management with SPC of the stencil printing process with a fully automatic stencil printer, what process outpur parameter would you recommend for SPC? It appears to me that there are two options: A: to have a pn chart based upon the % of
Electronics Forum | Tue Jan 12 17:56:18 EST 1999 | Jason Hall
| For process management with SPC of the stencil printing process with a fully automatic stencil printer, what process outpur parameter would you recommend for SPC? | | It appears to me that there are two options: | A: to have a pn chart based upon
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, CA USA
Phone: 18002796835