Electronics Forum | Wed May 03 08:43:51 EDT 2006 | Mark Fick
I have a DEK 265 with error code: motor comms failure.card 0, Axis123 fatal error-reinitialize machine during machine boost up I replaced new card 0 and still get the same error.I have tried to load the mint program but I cannot get program to abort
Electronics Forum | Sat Sep 22 01:30:31 EDT 2007 | mika
I am sorry my friend, but I can't recall that specific error number. But it would help if you explain a little bit more about your problem. Remember that an error code Do Not necessary points to a direct root-cause of a problem. First of all we nee
Electronics Forum | Fri Mar 03 10:45:10 EST 2000 | PAI
We are dealing with a unique machine that is having a couple of problems that we are trying to fix. A component code error appears whenever editing is done to any part of the program, array, or component library. This error we believe is causing t
Electronics Forum | Fri Mar 03 10:45:10 EST 2000 | PAI
We are dealing with a unique machine that is having a couple of problems that we are trying to fix. A component code error appears whenever editing is done to any part of the program, array, or component library. This error we believe is causing t
Electronics Forum | Fri Dec 02 17:28:35 EST 2005 | ratsalad
We have a TCM-V822 over in the warehouse that had a severe head crash. If you suspect you have a bad servopack, contact Unidec. They can test it for you. If it tests bad they can rebuild it for you and you won't have to wait for months to have o
Electronics Forum | Tue Sep 17 05:19:48 EDT 2013 | engineering@smtxtra.com
Hello, its simple the Panasonic tape is encoded, the non original splice tape you try to replace is not coded hence error on feeder sensor. we offer Panasonic replacement splice tape, for a sample please contact the office, hope this helps Robi SmtXt
Electronics Forum | Wed Jun 09 10:41:28 EDT 2010 | chrislyttle
We've been having some problems with out Fuji IP2E machine that we've recently bought from a company that is no longer operating here. Since installing it we've encountered a few problems with it starting up. To give you a quick breakdown of its be
Electronics Forum | Wed Sep 10 07:42:52 EDT 2008 | lloyd
Can you provide a bit more info on your machine setup. I not full fimilar with the S-27 so a few points may not be relevant to your machine. Are you using Siplace Pro. Are you using the standard GF for the 0201 component. Do you have the component
Electronics Forum | Mon Apr 13 14:48:38 EDT 2009 | bobpan
There is also a modify code that if set to 0 the quad-align will not turn on and you will have this error. It is one of the higher mod codes around 60-80......been so long i forget.... Good Luck Bob
Electronics Forum | Wed Dec 14 11:55:52 EST 2022 | proceng1
I have 2 SM421s in service and they still support mine. What is the exact error message? Did you look up the code? What step in homing is it doing when it fails? Maybe post a photo of the error list or message that pops up?