Electronics Forum | Thu Jun 22 11:01:54 EDT 2000 | Chrys Shea
Jason, Double sided reflow should be no problem. People have been doing it for years. The surface tension of the molten solder will hold the components on the bottom side during your second pass. This is almost always the case, unless you have re
Electronics Forum | Thu Jun 22 11:02:13 EDT 2000 | Chrys Shea
Jason, Double sided reflow should be no problem. People have been doing it for years. The surface tension of the molten solder will hold the components on the bottom side during your second pass. This is almost always the case, unless you have re
Electronics Forum | Sat Oct 02 20:19:19 EDT 1999 | John Dwinell
| | I am currently in the middle of a company wide war and I'm looking for data (AMMO). Here are the problems: | | | | 1) I am looking for anyone who has done or seen any reports on Thermal Shock to smt parts and/or via holes caused by Soldering Ir
Electronics Forum | Fri Jun 02 17:19:56 EDT 2000 | Big K
I am currently experiencing several problems with QFP's on one of our IP3's. The first problem is with QFP240 devices. We are experiencing a high reject rate with these parts when using vision type 100. What appears to happen is that the vision syste
Electronics Forum | Tue Oct 10 12:56:15 EDT 2000 | Ken Van ZIll
I agree that homplate is a good design, but also this could be caused by the stencil thickness and aperture size, if you are at 7-9 mils thick stencil and a 1:1 ratio on aperture size then 2 things i know of will happen, one a squishing out of past o
Electronics Forum | Thu Jul 20 12:49:05 EDT 2000 | Bob Willis
So far on all my trials on PIHR I have only used standard products as the paste is defined by the printing requirements for fine pitch etc. As most people will have seen you just get a heap more residues with this process and even more with lead free
Electronics Forum | Tue May 29 16:52:07 EDT 2001 | hussman
By far the easiest way is to track solder paste measurement on your board - or solder defects after reflow (key word- easiest). Why spend 2 weeks examining a stencil when it clearly doesn't make defects, or IS making defects. I find using 2-D data
Electronics Forum | Wed Jun 13 13:50:49 EDT 2001 | DaveG
I don't have any actual "hard" data to give on improvements but, I can share some experiences with you. What we noticed when we implemented the Rheo pump was: No more solder "skips" on our boards, Improved print quality on our BGA's & 16mil fine pitc
Electronics Forum | Fri Dec 17 16:25:05 EST 1999 | Brian W.
I used an off-line paste height measurement device to control my paste process. I did not inspect every board, just a random sample once an hour. I have used both manual and automatic devices. I like the automatic becuase: 1 - I have no "operat
Electronics Forum | Tue Nov 09 17:12:38 EST 1999 | Dave F
Steve: Addressing your points: 1 FINE PITCH APERTURES Electropolishing Laser Cut Stencils: Laser cut should not requiring polishing. Geesh, how much money do you have for stencils? ;-) Oval Shaped Apertures: Pass. What do you expect to gain f
winsouce.jpg)
