Electronics Forum | Tue Apr 18 14:06:56 EDT 2006 | samir
Has anyone done a Wave Solder flux evaluation lately for no-clean/VOC-Free/lead-free? If so, please do share some feedback. Who're the best candidates out there, etc?
Electronics Forum | Tue Apr 18 18:34:57 EDT 2006 | George
Try 270WR flux from AIM solder. It showed very good results on our wave solder process. Let me know yours... Thanks, George
Electronics Forum | Wed May 03 12:43:55 EDT 2006 | patrickbruneel
Chunks, You should have been in marketing But as a flux manufacturer I have to make a small correction Solder is the muscle flux the nerve
Electronics Forum | Wed May 03 15:04:25 EDT 2006 | Chunks
Does that make the board the bone? If so then the components are tendons? I knew I should've stayed awake in Bio! Flux manufacturer eh... Is it true that flux is made in big vats by witches?
Electronics Forum | Tue Jun 20 06:39:02 EDT 2006 | Julien VITTU (STMicro)
I'm using a lead free solder paste, low residue from SENJu among all the pastes I've tried it is the best I've found. you can ask for any type of alloy, but request the 729C flux type. kind regards
Electronics Forum | Tue Jun 20 09:28:30 EDT 2006 | cuculi54986@yahoo.com
We evaluated four SAC305 pastes. Of the four, we found Alpha OM-338 to appear to have the least flux residue. We also found it to be the most dull, least shiny, most non-SnPb looking of the four.
Electronics Forum | Wed Jul 05 10:13:02 EDT 2006 | jdengler
Is the flux rated for lead free? These higher temps will cause most lead rated fluxes to burn off prior to the wave. Jerry
Electronics Forum | Thu Jul 06 04:41:58 EDT 2006 | Rob
MF300S is quite an old flux, & a lot has happened since then on the flow solder front - are you sure it's designed for Lead free, or is it just a traditional flux that SHOULD work OK with Lead free?
Electronics Forum | Mon Jul 10 07:46:51 EDT 2006 | ronalds
You are right, RSS profile is not the correct description. I am using a profile which heats up quickly to let the flux spread. Next linear up to activate the flux and prevent thermoshock. My experience is however, that small changes in this profile
Electronics Forum | Tue Jul 04 07:40:22 EDT 2006 | slaine
I had a couple of reps in from Indium a few weeks back, and they were promoting a flux for rework that was designed to have low SIR, No clean. Havent tried it yet. The product is Flux NC 771, might solve your problem? Regards Slaine
