Electronics Forum | Tue Mar 28 15:11:56 EST 2006 | GS
Hi MLC, did you profiled the BGA itself? I mean detect Temperatures on middle/central ball vs external ball and see how much is the delta Temperature. Best practice is to keep the delta T at minimum as possible especially on a so large BGA. Sure
Electronics Forum | Sun Mar 19 16:32:05 EST 2006 | ausajid
hi same sort of broblem v r getting after reflow. i am not sure about the solderbeads how u can reduce, but the other issue u r talking about is apeture blocking.... u can reduce it by reducing the seperation spead. reduce it as low as 1-2mm/sec. th
Electronics Forum | Mon Mar 20 08:36:30 EST 2006 | jdengler
I've never had this problem on an Omniflo oven, but have seen it on others. It has always turned out to be mechanical. A bearing going bad or FOD in the rails. I would pull the chains and carefully check each link of both chains, all of the bearin
Electronics Forum | Tue Mar 21 07:31:54 EST 2006 | cyber_wolf
We had the exact same problem on our OMNI 10. We found that two of the rails the pin chain rides in were warped. Somehow at one point our PC lost communication with the oven and the heaters went wide open for several minutes...this is what caused th
Electronics Forum | Mon Mar 27 02:08:25 EST 2006 | AR
Up till now we have been using the Tribol 930 but it is practically impossible to obtain here in Europe at least. Speedline is extremely reluctant to sell it for some reason that I cannot figure out. Currently we are testing Anderol XL 220 but it is
Electronics Forum | Mon Mar 27 11:03:06 EST 2006 | mapell
Tribol 1430 is the latest generation oil, 930 can't take lead free temps. Please see the following link.... http://www.castrol.com/castrol/productdetailmin.do?categoryId=82958955&contentId=6004371 If your getting alot smoke and residue, reduce the
Electronics Forum | Mon Mar 20 16:54:37 EST 2006 | Chunks
If this is the plastic tpe cleaner, be careful of the heater rod switch. They had a tendancy to get stuck in the "on" position. This heats the tank water up. If left over the weekend, it will evaporate the water and heat the remaining plastic. Fi
Electronics Forum | Wed Mar 29 23:52:45 EST 2006 | ____
Using the 120,121,122 series is what you should try first frontlighting. The P Pattern will probably be "4". If this does not work, blacken the background disk (paint) and then use vision type 124. This will give you a great image if the 120 series d
Electronics Forum | Tue Mar 21 17:44:45 EST 2006 | omar_verdugo
hi all, could someone have an idea, would it be the best method to attach a flex cable to a pcb. right now, we are using a hot bar to solder the flex to the pcb, but we are having troubles with this method. the process is no regular all the time a
Electronics Forum | Sat Mar 25 16:36:44 EST 2006 | Frank
Comtra doesn't usually sell directly to the end user. Try consulting your machine manufacturer. On the mechanical belt feeders there are no adjustment. On the electrical feeders there is a turn switch to select the feeding travel of the belt. T