Electronics Forum | Mon Dec 21 10:52:41 EST 2009 | boardhouse
Two other outside labs you can try. Robisan Labatory 6502 E. 21st Street Indianapolis, Indiana 46219 (317) 353-6249 Phone (317) 917-2379 Fax http://www.Robisan.com The Specialty Lab, Inc. 2515 Terminal Road Dock F Roseville, MN 55113 Phone: 651-635-
Electronics Forum | Thu Dec 24 10:07:42 EST 2009 | edwaterfall01
Get two connectors to fit the SMEMA 1 connectors on either end of the machine. Need only two wires on each connector going to momentary contact sw. Input is pins 1 & 2 to switch and output side is pins 3 & 4 to switch. If this doesn't work then ch
Electronics Forum | Mon Dec 21 12:52:51 EST 2009 | ryanmiller
I need to find someone that can do an install and general training for a BTU VIP98N, in the Cleveland area, quickly. Please let me know if you or someone you are familiar with can provide that service. Thank you. Ryan Miller 214-403-7886 rmiller@d
Electronics Forum | Wed Dec 23 14:05:13 EST 2009 | spitkis2
Thanks for the replies. I haven't soldered to a chrome plated pad in the past and have my doubts so thought I'd ask here. Our customer supplied the material and for some reason decided to change the plating to chrome. We only found out about this
Electronics Forum | Mon Dec 28 08:03:05 EST 2009 | rgduval
I haven't checked, but... CircuitCAM maintains a master database with all of the information in it. I've opened mine in Access. I would assume that in the DB that contains the BOM information, there's a polarity field that is either true or false.
Electronics Forum | Wed Dec 30 15:05:18 EST 2009 | bobpan
Craig: Make sure you have done a table changeover and then when you go into teach tabletop there should be a tab at the top that says matrix trays. After selecting that ...choose the tray you want below and then right click on a part on the tray in t
Electronics Forum | Thu Dec 31 12:32:29 EST 2009 | vetteboy86
Thank you very much for the input. I figured out my problem to be that once I defined the tray, I did not changeover the table top just as Bob said. I'm good to go now, I think anyways. I was so used to the IQ feeders, changing over the matrix tray
Electronics Forum | Mon Jan 04 16:55:47 EST 2010 | dyoungquist
We use a HEPCO model 3000-2 (hepcoblue.com) to shorten leads on various through hole components before we solder them on a pcb. You will have to verify they have a die that works with your particular LED module. If they do, this is what I would rec
Electronics Forum | Tue Jan 05 17:31:12 EST 2010 | mlerley
Howdy folks! Your friendly neighborhood SMTnet.com programmer here. I've spent the last couple of years adding features and fixing bugs for y'all, and now I need some help. The board attached to this post is an inverter for an LCD display fluoresc
Electronics Forum | Wed Jan 06 09:38:59 EST 2010 | lynn_norman
Via failure could be caused by cracks in the barrel, or thin plating, or fractures in the traces leading to the vias, . X-ray analysis could pick up a fractured trace and cross-sectioning of the vias could pick up the cracks and thin plating. Secon