Electronics Forum | Mon Jul 01 04:58:50 EDT 2019 | SMTA-David
Hi, I have been looking around for an 8 zone reflow oven with convection heating top and bottom and computer control for setting up and storing profiles. The Chinese company "Jaguar" have a couple of models at reasonable price that look like they wo
Electronics Forum | Tue Jul 02 04:12:06 EDT 2019 | directx995
Hello everyone, Here is the question: What is the maximum q offset which can be corrected on polarized component? This question is refereed to Machine/Process Management segment of PCBA. I rly don't get this question, can any1 help? Where should
Electronics Forum | Wed Jul 03 06:52:27 EDT 2019 | bobpan
Seems to be fighting to hold its position. 1. Check for anything worn out...possibly idler bearing/pulley and/or the belt. 2. Maybe it could use servo tuning...this may help but usually servo tuning is not that critical. 3. Clean the scale and the
Electronics Forum | Wed Jul 03 08:10:34 EDT 2019 | bobpan
The amp is mounted on the back side and is black. 4 total mounted for x and y axis.....swap the 2 that are y axis amps. If you have never servo tuned before on a quad machine you not going to be able to do it. There is way to many things that you nee
Electronics Forum | Mon Jul 08 11:26:04 EDT 2019 | daniel_marquette
Swaping Y amps from a correctly working QSP-2 to this QSP-2 did not change anything: belts still vibrate. However, belts are in good shape, tension has been adjusted and bearings are turning free without play. Will try to swap Y motors from a corre
Electronics Forum | Mon Jul 08 15:20:12 EDT 2019 | daniel_marquette
Steve, all the worn carrier clips (chipped, spring less or damages, etc.)have been changed for working ones. Alignment has been performed to loser and afterward thighter tolerances than the manual recommend to see if it changes anything (no). I check
Electronics Forum | Tue Jul 09 07:35:48 EDT 2019 | stephendo
Watch the air pressure gauge and make sure you have a good steady air pressure. I don't know about the Rad 5 but the Rad 3 was sensitive to fluctuations in air pressure. By any chance do you have a VCD running nearby when you are having the problems?
Electronics Forum | Tue Jul 09 14:02:01 EDT 2019 | daniel_marquette
Unfortunately, I don't get the Jig but the component is always the same LED. I measured a sample of those and they are consistent from the tape and after the leads being cut. About 1-2% of the component from the tape are already bent so I'm still foc
Electronics Forum | Wed Jul 03 13:14:01 EDT 2019 | markhoch
Hey Process Peeps, I'm looking for a supplier of PCB Inspection templates for use at Wave Solder Inspection to verify placement and polarity of specific component locations. (This would be a template that the inspector would overlay over the PCB dur
Electronics Forum | Fri Aug 02 07:19:02 EDT 2019 | jchris
The response from SolderingPRO is quite amusing, considering he's the OWNER of Promation, distributor of Quick soldering irons in the US. By the way, Quick is a cheap, Chinese knockoff brand that has virtually no support in other countries other than