Electronics Forum | Tue Sep 15 19:54:13 EDT 1998 | Wayne Bracy
| Dear Dynapace and those who responded: | Sorry we were not quick enough to delete this ad. However, this gives us a chance to discuss with both users and vendors on ways to facilatate the desemination of product informtion other than via the Forum
Electronics Forum | Wed Aug 26 08:18:54 EDT 1998 | Earl Moon
| To All, | We have found several fake e-mail addresses on the Forum, most of them from one individual. We hereby announce that the following addresses are fake: | hello@smtnet.com | hi@smtnet.com | astounded@smtnet.com | thrilled@smtnet.com | The SM
Electronics Forum | Fri Aug 07 07:44:56 EDT 1998 | Earl Moon
| | | No sour grapes, | | | This has gone on too long. I expect no free advertising, nor do I seek it. It is clearly understood Bob is an industry leading consultant. What is not understood, at least by me, how he is allowed to "advertise" so freely
Electronics Forum | Fri Oct 11 14:33:55 EDT 2002 | seand
Hello Dave, I like many, do value your input to this forum. You do provide a wealth of technical knowledge and for that I would say alot of us thank you. However, there are 2 ends of the forum spectrum.....irresponsible reps........and those who f
Electronics Forum | Sat May 27 19:39:23 EDT 2006 | grantp
Hi, This must be the worst advice I have ever seen given on a forum. Really if you do what Guru says here, your going to go out of business so fast it's amazing. It personally cost me hundreds of thousands of dollars when I had to retire MYDATA
Electronics Forum | Fri Mar 16 16:26:34 EDT 2007 | James
This shows once again that this "what to buy?" and "What do you think about this machine..." crap really has no place in this Forum in my opinion. People have to get off their ass and do some investigating on their own. You have to be living under a
Electronics Forum | Tue Mar 14 07:59:41 EST 2000 | JAX
Emmanuel, The discussion on what finish to use whether it be HASL, Immersion gold over nickel, Organic Solderability Preservatives, ect...... is still ongoing. This is not the only decision you need to make. Do you plan on Soldermask Defined Pads? Wh
Electronics Forum | Tue Mar 14 21:22:41 EST 2000 | Dave F
Bingo!!! By panelizing and adding breakaway rails (as Nancy says), Stuart can pour copper up to his board fab's tolerance from the board edge. Traditionally, he just wants to make sure no copper shows on the edge of the board. Then again, it's his
Electronics Forum | Fri Mar 10 09:01:44 EST 2000 | Wolfgang Busko
Hi John, we had one shot with silver coated PCBs. With "no clean" and no changes in process parameters ( we had no input on necessary changes from the boardhouse ) we encountered wetting problems in the first reflow soldering process. Later it was s
Electronics Forum | Thu Mar 09 05:44:07 EST 2000 | Wolfgang Busko
Hi Edmund, J-STD-013 "IMPLEMENTATION of BALL GRID ARRAY and other HIGH DENSITY TECHNOLOGY" should be a great help for you. Component manufacturers ( try Motorola via Internet) also give good advice. For the DFM aspects get in contact with your asse