Electronics Forum | Mon Jun 19 11:16:22 EDT 2023 | eurolan
Hi guys, we managed to fix it. This tool turned out to be impossible to find. What we did is mount the motor, mark the timing belt's position and loosen the screws that attach the timing belt to the head. This way we were able to move the position of
Electronics Forum | Mon Jun 19 20:37:59 EDT 2023 | stephendo
I recommend Denise Hagge d.hagge@vtekusa.com> but they have a minimum order quantity. You can at least check out their web site. One time we needed tape and reel before we had the module built. Everyone else pretty much wanted exact dimensions
Electronics Forum | Tue Jun 20 19:12:41 EDT 2023 | madisreivik
Hello all ! FUJI IP3 starts up, makes zero setting OK But if I start AUTO mode, it gives error -------------------------------------------------------------------------------- Code 11082010 UsedBy MTU3,MTU4,MTU5 Display Usable Proper Data has
Electronics Forum | Tue Jun 27 05:28:32 EDT 2023 | ttheis
We powered up our Advantis machine after leaving off for several months. When we powered it up went to zero it we get an error on the y1 axis during zeroing. Command move home: pattern step 0. The y negative limit is hit during homing, the axis then
Electronics Forum | Thu Jun 29 00:33:15 EDT 2023 | auriga2001
My background is in I.T. Here's what's likely the cause. It's old and worn out. Not much else to offer technical wise. Hard drives are mostly permanently sealed to keep dust out and have moving parts. Eventually they wear out. The way to prevent fail
Electronics Forum | Thu Jun 29 03:04:19 EDT 2023 | ttheis
The first thing we do with all machines we buy is back them up. First we backup the calibration info, then we remove the hard drive and image it to our server. If the hdd dies, we can restore it to a new one. Look on eBay for new-old stock on the har
Electronics Forum | Fri Jun 30 14:13:23 EDT 2023 | calebcsmt
Is a bridge considered a defect, if adjacent pads/component leads are electrically connected (common) via a trace but said trace is covered in solder mask ? Essentially, of course bridges are never a target but is rework required/de-bridging require
Electronics Forum | Fri Jun 23 21:10:29 EDT 2023 | meher
To resolve this issue, you need to ensure that the proper data is stored and transmitted to the MTU. Double-check the communication settings between the machine and the MTU during the startup process. Make sure that all the necessary data is being se
Electronics Forum | Sat Jul 08 02:10:31 EDT 2023 | unsung
Wipe down and clean the 2 Gold strips on Y Axis and the encoder ( located on both sides of the machines covers must be removed ) Probably has dirt happen to someone who had an old universal 2007 that was sitting outside in the open air for a few day
Electronics Forum | Mon Jul 10 13:08:21 EDT 2023 | ttheis
Thanks, I do recall reading about loading firmware onto some of the VME cards (VRM axis controllers I believe.) I will review this again. I agree that it seems to be some issue with reading axis position after hitting the home switch. The first thin