Electronics Forum | Sun May 08 00:07:42 EDT 2005 | Dr . Klein
Hello mrmaint You say that you do 100% incoming inspection at your site, Do you open every tray and look on the writing on every type of component? If you open the bag, how do you close it again (vacuum machine)? What is the inspection process? (Only
Electronics Forum | Tue May 10 00:09:46 EDT 2005 | Dr . Klein
Hello (pwh) I would like to know more about your process. What is the rezone you open the bags? Do you put any stamp on the opened trays before you enter them to the mcdry? What kind of inspection do you make before you enter the trays to the mcdry?
Electronics Forum | Thu May 05 17:15:46 EDT 2005 | russ
You got what I think someone has called a "cold melt". If you were to run your removal profile awhile longer you would not see this. Anyway, you don't have any issues as this is very common (at least in my experience). FYI I was thinking your oxid
Electronics Forum | Fri May 06 15:15:19 EDT 2005 | lyrtech
Hi, I have an INTERMITENT error on my FUJI IP-2 that cause to me many headaches. The error is " SERVO NOT GOOD". In the books, it means that it is relative to servo amplifier. But I can't assume that is the problem because sometimes the machine wor
Electronics Forum | Fri May 06 16:19:40 EDT 2005 | jdengler
Does the problem happen at start-up? Does the servo amp have an error? If yes to both, could be a bad cable, or a badly tuned servo amp. If after running and the amp has an error it could still be the cable but also brings in things like a bad motor
Electronics Forum | Mon May 09 17:49:28 EDT 2005 | chon
Inspect the cables specially in those area where cables have bendings with the motor motion. If they have something covering them or extra insulation try to remove it and inspect closely. If the machine runs and suddenly stops with this error and aft
Electronics Forum | Fri May 06 18:19:45 EDT 2005 | Dr. Klein
hello all. i would like to know a process for sampling scrap lever from siplace mechine (madamas prog). what is the everage scrap level? how many times should i sample scrap level during assembly? what are the steps operator should do for fixing hig
Electronics Forum | Sat May 07 04:40:04 EDT 2005 | grayman
Hi, There are many companies shifting lead free solder wave. My question is can anyone give me idea if we can still use our old solder wave machine for lead free eventhough the solder pot is stainless steel 316L? Our solder bath has titanium nozzl
Electronics Forum | Sat May 07 15:49:19 EDT 2005 | marcelll
Need a wiring info from somebody who have the schematics for a GSM running the old vision system AIM 3500. There's 2 cables plugging in the vision box, "vision DigA" & "vision DigB" with DB15 connector. I need the pin out of these 2 cables to con
Electronics Forum | Mon May 09 15:27:05 EDT 2005 | jdumont
We used the 92J a couple of years ago for a while. It performed very well for us. However when we started batch cleaning our assemblies the 92J post solder residue was not very easy to remove so we switched to Kester 256 which cleaned better. JD