Electronics Forum | Fri Feb 28 08:48:00 EST 2020 | SMTA-Joe
We've made the decision to move towards Gold Immersion on our PCBs to eliminate flatness issues with QFNs and BGAs. Land/component pad geometry, population density, and other factors, have made it necessary to ensure a near perfectly flat surface tha
Electronics Forum | Fri Feb 28 02:25:44 EST 2020 | midast
We have all spare parts for the DIMA (Nordsson) Dymaxion after our machine went for recycling. It was no problem with the machin. The problem was lack of support According to Aston it should only be one still running :) (I guess they mean in Europe)
Electronics Forum | Wed Mar 11 16:43:20 EDT 2020 | sumote
There is a 8lb steel plate that is held down by 4 toggle bolts at the top of the machine. Its where you load the cutting media. If that plate does not have a pressure gauge built into it, contact CCR. They will send you one free of charge (at least t
Electronics Forum | Mon Mar 09 16:28:48 EDT 2020 | sportsradar
Hello Sarason, Unfortunately the machine is no longer supported and we are such a small company we can not afford to replace this machine. Thank you for your advise, I will check for additional parts stuck in the machine (long shot but worth the time
Electronics Forum | Mon Mar 09 16:30:42 EDT 2020 | sportsradar
We have the software and our PC has been running the machine for approx 10 years. I just don't know why all of a sudden it decided to have this problem. :( Also I have the software if you think I can reinstall from the diskettes. Will check, and ag
Electronics Forum | Mon Mar 16 14:08:44 EDT 2020 | sportsradar
Thank you for your reply. So the machine should preform a zero set without the line controller being turned ON? I never tried starting the machine first so I am unfamiliar with this. Thank you again. This community is great. Sincerely, Katrina
Electronics Forum | Tue Mar 17 09:09:34 EDT 2020 | emeto
You should be able to operate/troubleshoot machine on its own. Not sure if you have to switch some key on the back to change the mode, or it will initialize on its own using the last program that has been loaded....it's been awhile. Line computer dow
Electronics Forum | Fri Mar 06 02:25:08 EST 2020 | bukas
it is not that big deal. you can use almost any generic grease. I use SKF bearing grease on CP45FV's. Just make sure you remove old grease, I use IPA and compressed air to do this. And don't put too much of it or too little. After greasing everything
Electronics Forum | Fri Mar 06 08:51:07 EST 2020 | richardcargill
We have mainly Philips equipment and use Alvania almost everywhere in them. Ball screws/linear rails etc . As has been mentioned, just clean as much of the old grease off as you can, then regrease and put the machine on a warm up cycle. We do this m
Electronics Forum | Tue Mar 10 04:37:44 EDT 2020 | luciano_zhang
I have a files need produce in a urgent time. It's 4 layers PCB with 3 OZ inner and out layer quantity need 10000pcs ,any one know which supplier is aviliable?