Electronics Forum | Wed Jul 14 21:14:58 EDT 2021 | mekmat544
Hello, I would lke to ask you about one issue. I am finding maximal level of impurity in solder pot with solder Sn99Cu1. I have limits for pure (delivered) solder, but I can not find limit for solder in pot in process. Could you help me where I can f
Electronics Forum | Wed Aug 04 18:12:27 EDT 2021 | tomdegas
I am trying to install an A12 tool on my MY15 and I get the following error: "F-TLMN-9: Failed preliminary fetch during installation" I looked it up and it says Operator error and that the tool is missing. The tool is in the tray and the MY15 picks
Electronics Forum | Thu Aug 05 14:55:32 EDT 2021 | tomdegas
Tom I did as you instructed but same results so I actually changed the harness that has the two sensors (LED and RECEIVER) on the Z motor with a new spare I had hoping that was the problem. Alas that didn't solve it either. Any other suggestions?
Electronics Forum | Thu Aug 05 17:37:28 EDT 2021 | SMTA-64387687
Did you grease the tool o-rings? If they are too dry, the head won't slide onto the tool. Also, make sure the tools are flat in the tray. I'm assuming that you aligned on the center of the tool. And, try cycling the non-spring tools, like A24, to see
Electronics Forum | Fri Aug 06 17:19:46 EDT 2021 | SMTA-64387687
It seems to me that something is out of calibration. I noticed that you were reinstalling TPSys. Did this start after the reinstall? Did you restore a backup of your parameters, or recalibrate the machine with new values? Try changing the tools to "n
Electronics Forum | Wed Aug 04 18:34:34 EDT 2021 | Serge
Hello, We have a problem to start our CP643. When trying to start the machine, it returns "machine waiting for vision board" We already did exchange all the pc boards (Vision, computer, etc...) We also did exchange the camera and the machine still
Electronics Forum | Fri Aug 06 11:25:48 EDT 2021 | stephendo
You really need your customer to provide a drawing of coated, keep out, and don't care. People new to coating don't realise the importance of having a don't care buffer area around the keep out areas. And conformal coating wicks up leads quite easil
Electronics Forum | Thu Aug 12 18:35:02 EDT 2021 | oxygensmd
Press emergency button, release it and you will get an error report. Sometimes table motor doesn't work properly on my EKRA E5 and I see where to search if something not okay. Let me know your results.
Electronics Forum | Mon Aug 16 03:23:29 EDT 2021 | korrapat905
Hi Kristof_K Thanks for advice, I try but still same. Afer checked, it's look the supply voltage not send out from panel to supply sensor and inverter. Now I rty to find new panel from 2nd hand. Thank you
Electronics Forum | Wed Aug 18 01:29:20 EDT 2021 | korrapat905
Ok, now we found the problem source. IM-556; panel control was damaged that cuase no supply voltage out to reference sensor, S2/S2.1 I would to share, thank you.