Electronics Forum | Thu Apr 29 11:07:03 EDT 2004 | arcandspark
You are right about the very poor support for smaller customers. I had told them we were looking for another paste and now they have sent the reginal manager and the US sales manager has come by to see what they can do for us. All they keep saying is
Electronics Forum | Tue Apr 13 19:47:05 EDT 2004 | davef
Glue has different mechanical, thermal, and electrical properties than solder. That's why all these very nice no-lead people are furiously trying to gin-up some wacky solder alloy, rather than using glue. Among the papers in the SMTA Knowledge base
Electronics Forum | Tue Apr 13 21:32:42 EDT 2004 | aqueous
Dreamy, OA fluxes / pastes have differing levels of activity. Most OA fluxes must be cleaned very soon after reflow. OA fluxes and pastes, while offering an aggressive flux package and a relatively easy removal (solubility in water), they are the
Electronics Forum | Tue Apr 13 21:33:48 EDT 2004 | qualitel
Hi Dreamsniper, It seen this is the major issue had been occurs you.( We had face all this issue last time too) We had done a lot of areospace products before and most of ours products is a must on class 3 spec. BGA is not that tough t
Electronics Forum | Thu Apr 15 01:29:35 EDT 2004 | pyro747
Hello Everyone, I am having a pin chain speed problem. The speed of the chain will slow down after start up of the oven. Example if you set the conveyer to run at 41 in/min, as the oven warms up of conveyer will slow down phycally but won't chan
Electronics Forum | Fri Apr 16 10:34:29 EDT 2004 | kauer
A couple of questions for You. How old is this oven? Does it have a history of problems? When I have seen speed variations with our Omniflow 7s it is usualy the encoder but it usually spikes rather hard in one spot. You can see this physically and by
Electronics Forum | Thu Apr 15 11:14:34 EDT 2004 | mikecollier
Our conformal coat area has recently requested changes to our bare board houses to perform a pumice scrub operation on the PWB prior to HASL plating and delivery to us. Our first lot received caused us to have void faults under multiple component ty
Electronics Forum | Thu Apr 15 11:53:37 EDT 2004 | Claude_Couture
Hi everyone, Our QC manager is bugging me about calibrating the TC readings on our reflow ovens. I keep telling him that doing a regular reflow profiling with a mole is sufficient to see if the oven temperature are normal. The manuals state that TC c
Electronics Forum | Fri Apr 16 07:34:10 EDT 2004 | Claude_Couture
Ken, thanks for your answer, it is much better presented than what I was fed by our qc. By "calibrating TCs" I meant the readings the controller is displaying on the screen. So that would be the converter that we would check and calibrate. Thank you
Electronics Forum | Thu Apr 15 16:13:13 EDT 2004 | pjc
Best recommendation is to compare the two machines with your boards and stencils. Either vendor should be able to arrange for a �test drive� at one of their demonstration facilities or at a local friendly customer. I�m afraid that your request for �o