Electronics Forum | Wed May 03 12:26:30 EDT 2006 | patrickbruneel
This is indeed yet another proof that under impulse of the RoHS directives all norms are flushed down the drain. Bean counters are slowly but surely taking over our industry because they no longer face resistance by form of standards. Even the basic
Electronics Forum | Thu May 04 04:47:28 EDT 2006 | rlackey
Hi Pat, Not going to change, but has changed. We were first notified about a potential change 2 years ago, but as we're such a volume user we could turn around and say no thanks. However as every one else has now changed over on commodity parts &
Electronics Forum | Fri May 05 09:52:52 EDT 2006 | Rob
I think perhaps you should revisit the choice and take another look at Universal Advantis, I-Pulse M2 & M4(low cost Assemblion), Samsung SM320 or CP45 Neo, Contact Systems C5, Fuji XP series, Juki KE2060, and Siemens Siplace. There is nothing wrong
Electronics Forum | Tue May 09 09:07:46 EDT 2006 | eyryren
C/O general manager Dear Sir This is Shenzhen comofaje Tech.co.,Ltd from China mainland We are the Associator of Hi-tech industry Association, so I think we can become your supplier in China. Now we have Four series products:1 SMT stencil wiping ro
Electronics Forum | Tue May 09 09:05:07 EDT 2006 | eyryren
This is Shenzhen comofaje Tech.co.,Ltd from China mainland We are the Associator of Hi-tech industry Association, so I think we can become your supplier in China. Now we have Four series products:1 SMT stencil wiping roll/wiper special for FUJI MPM
Electronics Forum | Fri May 12 06:13:55 EDT 2006 | slaine
Hi I use a lot of preforms for other specific applications. Personally I like indiums product but the lead time is awful and dont often deliver them on schedule. (im in the uk). Some manufactures make preforms out of solder wire that is pressed flat
Electronics Forum | Wed May 10 00:27:46 EDT 2006 | Chris
Russ, By a longer profile you mean a more even slope across the entire profile. Unfortunately I only have a 5 zone oven that is fairly short. How many heated zones are you using? Did you shrink the 0402 pad design and leave less pad exposed out a
Electronics Forum | Wed May 10 11:03:04 EDT 2006 | Mike Konrad
I would be far more concerned about the flux residue intentionally left on the board than the �dust bunnies� sticking to the flux. In �perfect� no-clean applications, flux residue, although present, is nearly invisible and marginally conductive. In
Electronics Forum | Thu May 11 15:11:14 EDT 2006 | patrickbruneel
I assume you talk about wave soldering. No-clean fluxes are widely used since 1987 or earlier and after all these years they have proven to be reliable. If you clean the board or not the dust bunnies etc. will still reach the board surface. If you us
Electronics Forum | Wed May 10 12:13:16 EDT 2006 | scombs
We have a 6 up panel with a 1206 part .082" from the board scoreline. After depanelization when we run the board through ICT it fails for a short at that location. We have visually inspected at high magnification for any cracks in the body and at the
.gif)
