Electronics Forum | Sun Mar 06 11:04:19 EST 2005 | jsk
Slot three will not recognize magazine. LED's are lit (green)when inserted into slot three. Magazine works in all other slots. Tried multiple magazines. All gave the same error. Error code = E-MIPR-1 unknown magazine type slot 3 No visible damage t
Electronics Forum | Thu Mar 10 15:13:31 EST 2005 | pmd
I agree with SirTec. Conflicts with other magazines slotted into machine often cause un reckognized magazine errors elseware. You can also try to re seat the first pair of MOT driver cards in computer this is whare mag data is stored. Also a loose ca
Electronics Forum | Mon Mar 07 08:53:59 EST 2005 | Marc
some thoughts come to mind..... usually an air pocket as the solder heats up, or the surface is still solid and liquid under, pressure builds and then... check your heaters, make sure one (or more) is not bad, may be getting uneven heating. cover y
Electronics Forum | Mon Mar 07 20:22:05 EST 2005 | KEN
Here are some general rules for lead free wave solder: Noble aloys will cost more. Period. The cheapest metal on earth is lead. Costs can only go up in Lead Free. Consumer grade and class 2 electronics will most likely use Tin / Copper for wave.
Electronics Forum | Wed Mar 09 12:34:19 EST 2005 | DasonC
You can use Cp and Cpk to find out your machine performance and accuracy. Some machine had it own software and kit. ie. Siemens. If you are using Fuji and you can visit the AD. on this web, TIMEKEY. Otherwise, you can use a high precision AOI with
Electronics Forum | Wed Mar 09 13:07:34 EST 2005 | jdumont
Good day all,we recently got our new xray system up and running and I am wondering if we need to report to the state,Rhode Island, that we have this onsite...anyone have any clues? The salesmen said we do not but id like a second opinion. Thanks JD
Electronics Forum | Thu Mar 10 04:12:01 EST 2005 | aj
Guys, I have a Dek Mk1-similiar to 265. I am having some intermittent problems with the Camera. The signal gets all fuzzy every now and again, by me disconnecting the power and reconnecting it works fine again . They are quite expensive to replace
Electronics Forum | Thu Mar 10 08:29:53 EST 2005 | jdengler
AJ, Dek recommended the replacement of the wire harnesses on the Mk1's often (I think anually). I never saw this problem on a Mk1 but many other odd problems due to breaks in the wire harness. They had this as a kit at one time but I haven't worke
Electronics Forum | Thu Mar 10 10:06:08 EST 2005 | steve
OK all you Gurus here's one for ya. Customer is tinning wires with standard eutectic solder in a solder pot. There is a blue tint to the solder in the pot. After tinning with OA flux, which I will change to NC shortly, he has clear teflon insulation
Electronics Forum | Thu Mar 10 15:43:06 EST 2005 | steve
Thank you both for your assistance. I knew that I could count on you folks. The customer has purchased No-Clean flux and is using it as we speak. Hows that for customer service.... All in a days work... Thanks again You make me look good!!! Steve
