Electronics Forum | Thu May 26 06:04:49 EDT 2005 | johnw
Hi Guys I have had this fault and it was traced to the ccd power module on the camera Zsolt I think I know you drop me a mail Tatabanya
Electronics Forum | Mon Apr 26 08:15:37 EDT 2004 | pjc
MPM uses a one-print-Mylar system, as do other printer mfrs. In this system there is a Mylar sheet attached to a frame that is secured over the printer table with the board on it. You print onto the Mylar. The table X-Y-theta manual adjustments are u
Electronics Forum | Mon Apr 26 15:04:14 EDT 2004 | pjc
You are correct in understanding that the vision system comes into play for subsequent boards- to align them. Yes- if you missalign the first board and set the cameras to that board, all subsequet boards will not be aligned. Mylar is a thin polyester
Electronics Forum | Wed Aug 04 18:34:34 EDT 2021 | Serge
Hello, We have a problem to start our CP643. When trying to start the machine, it returns "machine waiting for vision board" We already did exchange all the pc boards (Vision, computer, etc...) We also did exchange the camera and the machine still
Electronics Forum | Thu Dec 27 17:13:02 EST 2007 | mee13
The CP643 has a 0201 camera and a dual board loading system
Electronics Forum | Sun Apr 09 14:20:17 EDT 2006 | greatexpectations
Hi, This setup was recommended. Target is 20,000 board output per day FUJI GL-541 Glue Dispenser (USED) 32K FUJI GL 641 SCREEN PRINTER (USED) 57K CP-643E CHIP SHOOTER 255K (150 FEEDERS) FUJI QP-242E IP3 110K REFLOW 8 ZONE (IS THIS ANY GOOD) 4
Electronics Forum | Wed Feb 01 00:10:32 EST 2006 | kent
Are you seeing this problem with the nozzles after an error stop? Well check station 15 confirm nozzle clutch origin. It will cause this problem. If you rotate a shaft (with the machine stopped) 45 degrees and start you will get return theta off and
Electronics Forum | Fri Aug 22 02:10:55 EDT 2014 | mdang
I wonder if anyone can help me with this problem. My FUJI CP65 with 0201 camera is working fine for a while. Now, it starts losing the vision on 0201 camera. The system will run for a while then I don't see the part on the part monitor when the nozzl
Electronics Forum | Mon Jul 26 22:14:22 EDT 2004 | pdeuel
Cognex version drives the vidio. If you are getting an image then cognex is not an issue. Thru bore calibration of the camera is the alignment of the upward looking with respect to the downward looking. One camera dose it all getting the image thru o
Electronics Forum | Mon Feb 16 01:26:30 EST 2004 | Frank
The 575 was based on the 570 machine. The 570 was Juki's first laser centered machine. It can do 0402 and ICs with a pitch of 0.65mm or greater. The 575, was a re-vamped 570 that Zevatech came up with. Juki played no part in the 575. Zevatech ad
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
