Electronics Forum | Thu Mar 10 14:50:56 EST 2005 | russ
Rob, Fantastic! I sure wish we would have put our requirements into our last P.O. The G.M of the manufacturer of this machine flat out promised and guranteed a certain CPH after reviewing the products that we would be producing. When the machine w
Electronics Forum | Mon Mar 14 11:41:39 EST 2005 | pjc
This company can come in to your facility with equipment to measure the pick-&-place machine's accuracy and repeatability of placements in X-Y-Theta: in North America, http://americas.cetaq.com/index.php?lang=en in Europe, http://www.cetaq.com/
Electronics Forum | Tue Mar 15 07:59:07 EST 2005 | mattkehoe
We are looking for some feedback on this situation. Please let us know if you have any ideas. Thanks in advance. I have been doing some studies on defects and such with our PCB's in prep for lead free and I've come to a conclusion about our process.
Electronics Forum | Tue Mar 15 09:46:06 EST 2005 | davef
Comments are: * J-STD-001 and A-610 committees have eliminated the requirement that solder joints be "bright and shiny". Certain metallizations (such as gold) can influence the solder joint surface texture, but have no impact of reliability. Reliance
Electronics Forum | Wed Mar 16 09:22:20 EST 2005 | russ
Try varying you conveyor speed as well to increase the dwell time on the wave (touchy, and can easily be overdone). Every no-clean type and process I have ever used will leave some type of residue. They can be minimized but they will always be ther
Electronics Forum | Wed Mar 16 20:11:03 EST 2005 | darby
KT, What sort of delta T are you getting? This does sound a bit odd. TCs are in EXACTLY the same position on each board? Something I only recently found out - according to Mark Cannon from ERSA re profiling, that you may wish to consider. 1.TCs sho
Electronics Forum | Tue Mar 22 07:39:05 EST 2005 | davef
There is no standard. This is a relative test. If you wish to do tests of this kind, we suggest to pay attention to the following points: * Shear strength of soft solder depends on the deformation speed applied. The faster the material is deformed t
Electronics Forum | Tue Mar 22 12:11:15 EST 2005 | jdengler
Bob, I don't have 300 stencils only about 83 so my way might not be practical for you. This is what I have done. 1. I have racks that hold 20 stencils, 10 top 10 bottom. 2. Number the racks and have them in order. 3. Made a number system for locati
Electronics Forum | Wed Mar 30 20:06:07 EST 2005 | Sue PH
Ken, I run a Triber and have a manual. This machine was bought used and came to this company before I did. It looks like the manual is a copy and someone wrote Treiber 700B-16F on the front page. I don't know if this is the same machine as yours o
Electronics Forum | Fri Apr 08 13:10:59 EDT 2005 | HOSS
Our traveler contains PN,rev,batch #,where used, due date and the other usual info. We then list the entire routing. At the bottom of the page, we list all of the relevant documents for that product that are available via an electronic doc retrieva