Electronics Forum | Fri Jul 26 14:19:14 EDT 2019 | slthomas
Since our process engineer took off for allegedly greener pastures I've taken it upon myself to provide whatever assistance I can with the process side. In this case I'm trying to get the "2 1/2D" inspection up and running. They've never us
Electronics Forum | Tue Nov 05 10:55:41 EST 2019 | engmagana
Hi Ameen, Did you fix it? I had the exact same problem with the same type of coil , check the images , LF solder SAC305, we have adjusted the solder apertures to the minimum solder required to have a strong joint enough to break the pad from the bo
Electronics Forum | Mon Aug 12 16:46:58 EDT 2019 | stephendo
"mostly an irritant" can be serious for some people. You can get other toxins from PCBs if you char them but you would have mentioned if they came out burnt. Was there any exhaust on the oven at all? I have seen it where we used a particularly stink
Electronics Forum | Wed Aug 14 18:17:32 EDT 2019 | slthomas
We are down to the last few unresolved PCBA test failures in a work order and scrambling to get them repaired and into a mechanical assembly. What we have found in quite a few of these cases are cracked 1206 MLCCs. The failed parts are all the same
Electronics Forum | Wed Sep 04 13:32:22 EDT 2019 | bobpan
Try these things: 1. Do a function 30....your nozzle height should consistently be around 200 +/-20....but whatever number it does find it shouldn't change. (with nozzle on) 2. Most times its the z-bellows....an old z bellows that has a worn out spri
Electronics Forum | Fri Sep 06 11:59:20 EDT 2019 | SMTA-Eric
In regards to machine utilization of an automated in-line SMT Placement equipment, is there any statistical data that may indicate what a typical line should expect to achieve? What is a reasonable target for a low volume high mix production environm
Electronics Forum | Wed Oct 09 10:25:41 EDT 2019 | slthomas
In general I'm against them but I do understand that sometimes a valid reply to a post could be from a representative for a *paid* advertiser and a real solution to a problem could be their product. That said, posting a barely relevant comment on a
Electronics Forum | Sat Nov 09 20:08:34 EST 2019 | kylehunter
> Yeah, sorry, just noticed that bit on the > photo. I'll have to have a look at my machine on > Monday to see if there's anything that might > explain it. The pressure system is pretty much > the same on all the 265 variants so if
Electronics Forum | Wed Aug 26 18:36:17 EDT 2020 | serge_pirog
Hello. Could I ask you for help. We have DEK Europa. We have changed ProFlow to squeegee head with feedback. After this during solder paste printing system shows the difference between set pressure (9 kg) and real pressure (7,5kg). I have read manual
Electronics Forum | Wed Nov 20 15:03:27 EST 2019 | richardcargill
If you've formatted the pcmcia / CF card then it'll be blank and have no DOS or anything as it acts as the hard drive for the machine. A DOS diskette formatted with /S will boot from the floppy drive, then allowing software installation with the orig