Electronics Forum | Wed Jan 24 12:42:25 EST 2001 | traviss
I�m suddenly getting a very high failure rate in a TO99 component (National LM136AH-2.5). After some investigation we found some of these parts are more than 20 years old. What I am hoping for is that someone out there can help me find some standards
Electronics Forum | Tue Jan 30 15:30:17 EST 2001 | dason_c
Please check what is the actual pitch size. I found some of the designer use 15.7 mil pitch and no accumulate ie 15.7, 15.7 and 15.8...... Also, I recommended the pad width should be 10 - 11 mil for 0.4mm pitch. You can open the 10 - 10.5 mil aper
Electronics Forum | Tue Feb 06 10:55:58 EST 2001 | pjc
Larry, Our specification is 0.075% for our Fuji CP3 and IP2 machines. At or above that figure the Maintenance Dept. has to get to work. We typically see 0.03% to 0.05% on average. The Fuji machines are all vision centering. We have found feeders are
Electronics Forum | Wed Feb 07 12:56:00 EST 2001 | jax
I' ll have to agree with Dave on this one. Just get the information from the Suppliers. The Glass plate, Aluminum board, Glass slugs, etc... are all used to determine if a calibration is needed or if it was succesful.( they can also give you offset i
Electronics Forum | Tue Feb 13 06:43:44 EST 2001 | jackofalltrades
We use AOI in-line on most our SMT lines, and still getting them for the rest our lines. It has cut down on Inspection Time considerablly, justifing the cost. They do take a trained technician to program and that is a little time consuming, but worth
Electronics Forum | Thu Mar 01 13:42:01 EST 2001 | slthomas
Let's see how this works.... http://www.freedrive.com/GetMain.asp?affiliate=10406&menuset=explorer&menuid=explorer&us=ACTIVE Click on the Sn_Pb tsunami folder (not the camera lookin' thingy) Too bad they'd already started cleanup. The slosh hit t
Electronics Forum | Thu Mar 08 16:00:03 EST 2001 | gsmguru
Enter A value of -1 in the Tray pickup X & Tray pickup Y fields. This will disable the automatic empty tray pickup by the machine. I would recommend getting a data sheet on the tray from the component vendor for accurate pocket & tray dimensions. Var
Electronics Forum | Thu Mar 22 08:54:06 EST 2001 | dblsixes
I'm not familiar with Laser Soldering. I don't believe it to be a problem with the QFP themselves, since the two plastic parts are from different vendors in the same package. We also are having similar problems with other plastic parts on other boa
Electronics Forum | Thu Mar 22 16:02:37 EST 2001 | dblsixes
In the end, we may have to go to our customer to see if we can get Class 3 relief ... We actually did an experiment by adding a ceramic cap to the top of the part, using a thermal paste to improve the thermal connection. It didn't do much for us ..
Electronics Forum | Fri Mar 23 10:57:09 EST 2001 | blnorman
Go to http://www.ipc.org/html/fsresources.htm, scroll down and click on downloadable resources and IPC-65-650 is there for the downloading, free. The problem is that you have to download each individual test method, you can't download the entire doc
