Electronics Forum | Sat Aug 13 23:41:31 EDT 2016 | sarason
Download PCBSynergy which is located here. http://members.iinet.net.au/~sarason/ It has outputs for the KE750,KE760 and 2080 from Juki It will read a large number of CAD formats. Including Altium PCBDOC, and Protel PCB and all the variants inbetwe
Electronics Forum | Thu Jun 02 08:18:57 EDT 2016 | emeto
You have to define inexpensive. Good machine will be Juki or Samsung that cost less than Siemens, Fuji or Universal.All of them good in a different way and just like everything else, the more expensive it is the better. If these are expensive you sho
Electronics Forum | Fri May 20 10:09:02 EDT 2016 | ttheis
Unless your products are rather simple or throughput is not a major concern, you are going to have a hard time finding all of that equipment on that budget without considering used equipment. A low-end pick and place machine will consume that entire
Electronics Forum | Thu Jun 02 09:33:50 EDT 2016 | emeto
Hi, if I were you, I would probably go for testing and rework equipment. Adding manufacturing to your business, will most probably exceed your preliminary expectations. Manufacturing is much more complicated than you probably think. I have used manu
Electronics Forum | Sun Jul 10 15:25:20 EDT 2016 | bradholland
hi martin, i can help with the manuals. I just got a 740 myself and am completely new to it all. Have been learning the machine over the last couple of weeks and have it now placing my board quite nicely. however, for all my 0603 resistors, it seems
Electronics Forum | Wed Aug 24 22:11:36 EDT 2016 | davef
I'd guess that "black pad" is not the issue that you need to address, because only 2 of your 5 test points has the problem that we seem to be discussing. I'd expect "black pad" problems to be more wide spread. Something is going on at those two locat
Electronics Forum | Wed Jun 29 16:30:48 EDT 2016 | proy
We have been studying and learing how to work with an older Seica Pilot (S20 software) flying probe tester. A third party company has been very helpful but they are not that familiar with the S20 software. Looking for someone with knowledge of the S2
Electronics Forum | Fri Sep 09 06:03:37 EDT 2016 | jswatt
Simple answer is no you cannot do it and why would you?.. is it a cost saving thing? As Dave F correctly points out you have a fair amount of noxious fumes to handle that aren't getting exhausted if you switch of the extraction so they will go to you
Electronics Forum | Tue Jul 19 18:08:28 EDT 2016 | dman97
Hello, I am having trouble getting our old CP3 to start up. When the machine starts to run, or when we try to center the nozzles, the CAM moves to 300 degrees and stops. The station 5 rotor just turns and turns with out ever centering the nozzles.
Electronics Forum | Thu Jul 21 14:54:32 EDT 2016 | ttheis
Acetone is flammable and hazardous to deal with. The fewer fire hazards and nasty fumes the better in my opinion. I would either go with a alcohol based no-clean for economical processesing and boards that can't be washed, or water washable if you ca