Electronics Forum | Thu Sep 18 14:59:46 EDT 2008 | bobpan
Check the fuses on the quad align card. There are 2 on each card. They are surface mount type. Typically one of these have blown. Good luck
Electronics Forum | Fri Oct 03 15:18:27 EDT 2008 | davef
Good ol' general purpose, day-in, day-out ~$1k hot air rework stations are: * Pace ThermoFlo ST 300 Low Cost Hot Air Reflow System [ST 325 is digital] * Hakko FR-803B SMD Rework Station [FR-802 is digital]
Electronics Forum | Thu Oct 09 15:26:08 EDT 2008 | wrongway
We use campton tape also but we use a ultasonic stencil cleaner and the tape will come off everytime its washed good luck
Electronics Forum | Thu Oct 09 15:21:00 EDT 2008 | bing007
Check the Parmi range. I have looked at a Parmi SPI 2500 and seems a good machine. Able to store on a PC under product and creat SPC. http://www.parmi.com/product_en.html Steve.
Electronics Forum | Fri Oct 10 14:38:26 EDT 2008 | smt_guy
Hi, Where can I find good information regarding the specific soldering iron tip for specific component package that they can be used? Is there any websites for this? thanks and regards,
Electronics Forum | Wed Oct 22 12:13:18 EDT 2008 | brismittr
A no-clean paste with an above average amount of halides should do the trick. Kester EP256HA is a good choice for this application if you are using a leaded alloy (Sn63 or Sn62).
Electronics Forum | Wed Oct 22 12:46:05 EDT 2008 | hussman
Wire wheel works too. Pre tin the part. Hand solder after reflow. Or order good parts. I prefer the last one. Hows that for an answer?
Electronics Forum | Sat Oct 18 08:28:16 EDT 2008 | davef
Our friend Bob Willis does a good job of reviewing books. Check his site. Here's another list http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=46719
Electronics Forum | Wed Oct 22 01:14:04 EDT 2008 | maheshbs
Conveyor is installed after AOI machine. After inspecting the board in AOI it sends the signal to the conveyor whether it is Good board or Bad board.
Electronics Forum | Tue Nov 04 15:53:04 EST 2008 | mikesewell
Not specifically changeover software...but it will compare and highlight the differences between .xls files. Good for evaluating new ECOs from customers. http://www.grigsoft.com/wincmp3.htm
