Electronics Forum | Wed Aug 13 19:57:05 EDT 2014 | suroy
After wash cycle, some of the inductors are open (broken wire). Resistance across the two ends should be below 4 ohms (normal) however on broken wire shows above 200 ohms. I am wondering if anyone else has seen this problem. We are using High-Reliabi
Electronics Forum | Wed Aug 20 13:29:42 EDT 2014 | kkay
We have a small board that we run large quantities of. Unfortunately we cannot get them in a panel as it is an all aluminum board. Has any one successfully come up with a way to print boards in a pallet? These have fine pitch on them and the pallets
Electronics Forum | Mon Aug 25 02:57:43 EDT 2014 | arjunkolavara
We are in the process of qualifying our SMT lines for the High Melting Point Solder with alloy composition of 93.5 Pb 5 Sn 1.5 Ag.If any one has already an experience with this alloy,kindly do give ur inputs on the process of profiling . The reflow d
Electronics Forum | Mon Sep 01 13:46:11 EDT 2014 | max83
Yes, MC-24 and YS-24 are same platform, because Assembleone was selling Yamaha`s machines under name Assembleone till 2012 in the EU, Assembleone was distributor Yamaha in the Europe. Now Assembleon and Yamaha different machines. YS machines not so
Electronics Forum | Thu Sep 04 22:41:55 EDT 2014 | koalamotorsport
Hi folks. I need help identifying a replacement for this component, I believe it's a capacitor. It is marked AVX 9915 on one side, and 15uM and 15V on the other side. Unit in picture is the good one on the board, the one I need to replace has lit
Electronics Forum | Wed Sep 10 07:47:47 EDT 2014 | fnorradd
We have just recently purchased a Dage X Ray machine and in transportation the vacuum tube has lost its vacuum. Other than Dage, does anyone know of a company who is capable of re vacuuming the tube to the correct pressure? Any assistance would be
Electronics Forum | Tue Sep 30 12:09:45 EDT 2014 | tech1
If you are running a Mydata machine why don't you try one of the new stick magazines they offer. These magazines shake rather than vibe and the motion is controlled by the package dimensions. Call your rep and see if you can "borrow" one to try out.
Electronics Forum | Tue Sep 30 12:16:23 EDT 2014 | tech1
Check your pad sizes against the supplier recommendation. I have noticed that these LED packages are very light and easily move around during reflow. Human nature has us checking the profile and making changes when in fact it is usually something els
Electronics Forum | Fri Oct 17 16:31:53 EDT 2014 | dyoungquist
Per IPC-A-610D: Target is 100% vertical fill but 75% vertical fill is acceptable for Class 1,2,3. Only needing 75% fill of the barrel when soldering plate through on an 0.093" thick board with our selective solder has been a life saver at times.
Electronics Forum | Thu Nov 13 06:17:23 EST 2014 | aj
We use Buddy check system + part measure prior to all parts being loaded onto the machines...this is a manual approach but we haven't had a misload in years.... It has been mentioned above but the Operators have a huge role to play no matter what sy