Electronics Forum | Fri Feb 22 13:54:40 EST 2002 | seand
Hello Armin, If you are putting a matrix together to determine the best equipment set to use then a good path would be to start with your product and production expectations. Is this to be utilized strictly for typical SMT products? Are there any
Electronics Forum | Tue Feb 26 04:55:32 EST 2002 | mustservices
to use the fuji america office you have to be a registered customer, which we are not since we are based in the uk. we cannot go to the uk fuji agent either
Electronics Forum | Wed Feb 27 17:25:39 EST 2002 | JoAnn
This book, as well as many others on soldering, is available from the SMTA. It can be purchased on-line at http://www.smta.org. Click on Bookstore. Jesse in our office (952-920-7682) can also answer specific questions you may have.
Electronics Forum | Thu Feb 28 18:28:19 EST 2002 | davef
Smtneter have talked about this in previous threads. Search the fine SMTnet Archives. I recall reference to some articles in the SMTnet Newsletter by the dear departed Earl "Give 'em the moon" Moon. Check it aut.
Electronics Forum | Fri Mar 01 01:54:05 EST 2002 | abtaylor
Hi Marcos, If you need more information, I have a couple of books introducing and reworking BGA's. Details can be found at:- www.abtech-europe.com/smt/publications/prrsfpb. Barry
Electronics Forum | Fri Mar 01 06:19:41 EST 2002 | mrpsilva
Gentlmen, Thanks for the information. I am sure that I have some sources to star to study now!. Acctualy the volume of rework is not so much, but as we perform repairing in electronic baords, we try to work properly even in few repairing. Thanks aga
Electronics Forum | Mon Mar 04 03:56:37 EST 2002 | wbu
As I recall you need to connect them via serial interface. Make sure the setting on both sides is matching and that you have Rx and Tx connected in your cable. Don�t remember any troubles with data exchange with this baby. Wolfgang
Electronics Forum | Mon Mar 04 08:57:13 EST 2002 | DougS
I contacted IPC about the new IPC-9850 board used for machine characterization. Is anyone using this method for accuracy or cycle time between vendors? If you have, where did you get the boards and CAD/Gerber data from? IPC made the standard, but who
Electronics Forum | Fri Mar 08 13:21:30 EST 2002 | mhunter
Steven, I would like to review the documents as well as I have just recently approached this issue within our facility similar to Dave's point of view(referencing conformal coating).
Electronics Forum | Wed Mar 06 21:19:10 EST 2002 | davef
As an alternative, consider: * Asking your operators. * Having your operators keep logs and checking them with hands-on time studies.