Electronics Forum | Mon Apr 18 12:14:39 EDT 2022 | proceng1
As far as hole fill, as was stated above, class 2 only requires 50% up-fill. In order to get better up-fill on the initial pass, you may need to consider more pre-heat. Also, better application of flux. Are you using a drop jet, or a spray? You
Electronics Forum | Thu Apr 21 06:05:48 EDT 2022 | sophyluo1985
Hi,Dear All,Recently we have many customers asking us, FUJI NXTIII pick and place machine can use W08c feeder or W08f feeder, which one is better? We know the W08c will cost less than the W08f feeder. But there will still be some people who will be c
Electronics Forum | Thu Apr 21 20:45:09 EDT 2022 | SMTA-68235204
Hello: I am wondering what you all do with your flux stone at the end of the day? Do you remove the unit and store it in DI water or your thinner for the flux? Do you leave the stone in and just add your thinner to get to the correct specific gravity
Electronics Forum | Tue Apr 26 15:57:59 EDT 2022 | proceng1
I didn't look into the two pad layouts and what they look like, but here is what I tell my operators. When the solder goes to liquidous, the surface tension will pull on the part from each pad, essentially centering the part. Assuming that the pads
Electronics Forum | Mon May 02 21:26:23 EDT 2022 | rob1
I have a problem with DEK 265 Horizon. During camera being homed after checking the fiducials, the camera failed to home properly and crashed into the back of the machine in the Y direction. I homed the camera in the Y and it appeared OK and I could
Electronics Forum | Wed May 04 19:38:57 EDT 2022 | mikevb
I have a used MyData My9 machine that I've picked up recently and it has a problem with initializing that I can't figure out. It just gives an error stating "no z indicator value at all". I've replaced the flex board with the force sensors but that d
Electronics Forum | Fri May 06 06:54:56 EDT 2022 | jojoled
I have JUKI KE760L, and did notice that, when In "Feeder data " I select feeder position say 20, it enters XYZ coordinates for "pick coordinates" for example X=-260, Y=-25, Z=-1, which I need to "correct always by camera (it is slightly shifted).....
Electronics Forum | Fri May 13 19:33:37 EDT 2022 | alex22
Hi Chris. Thanks for sharing these details. We are working with Cree XP-G3 LED (3535). We bought urethane nozzle from CoT (recommendation from Cree), but it didn't solve problem of LED sticking to nozzle. Cleaning nozzle with isopropanol (other recom
Electronics Forum | Tue May 24 11:31:53 EDT 2022 | joost
We bought a second hand Saki Voyager AOI machine, all the systems seem to be working but I need to import data to start scanning for errors on pcbs. Now we have never worked with an AOI machine and are at a loss What I think I need is: solder past
Electronics Forum | Thu Jun 09 16:44:20 EDT 2022 | SMTA-68235204
We currently are using the HIPPO system. It is a nice program. It's cloud based so nothing is stored on sight. This was helpful when my computer crashed. You can add an immense amount of information into the system. If you can think it you can enter