Electronics Forum | Thu May 19 08:28:08 EDT 2005 | geb
Thanks for everyones help. I have resolved this by filling all but one of the nozzle holders in nozzle changer banks.
Electronics Forum | Sun May 15 22:49:18 EDT 2005 | techknow..
Tech sheet says that sealed container should not exceed 7 days....I have a container that has been out for nine days, what do you think????? Has anyone any similar experience or pointers ??
Electronics Forum | Mon May 16 10:43:22 EDT 2005 | wizy
I would like to ask, if somebody know, what I have to do with "L3 TIME UP" error message in MPA-V, or where can I switch off the coplanarity unit?
Electronics Forum | Mon May 16 15:53:17 EDT 2005 | adrian_nishimoto
This has been a problem with new components coming directly from vacuum sealed desiccant packed moisture barrier bags with moisture level cards. We have also baked all boards prior to the BGA rework to ensure no moisture issues were addressed.
Electronics Forum | Tue May 17 10:01:42 EDT 2005 | russ
I have had the same problem with this supplier, we found that one mfg. place or process used a .015" piece of FR4 as the base while others had .030" Fr4, We discontinued use of the .015" and never had a problem again.
Electronics Forum | Mon May 16 15:33:52 EDT 2005 | jasont
Hi Fred, Will you consider used waver solders? I wills end you a list of pre-owned, good working waves that we have in stock. Regards, Jason
Electronics Forum | Mon May 16 17:51:04 EDT 2005 | ASIR
Does anybody knows any outside service for SIR testing. I am being question if my cleaning process is good enough and I don't have any ways of proofing it.
Electronics Forum | Wed May 18 12:20:27 EDT 2005 | Tech
We have a panasonic MSR and keep getting collation errors and not sure how to remedy without shuttingdown machine and starting over. Any suggestions would help? Thanks.
Electronics Forum | Wed May 18 17:05:41 EDT 2005 | splice1
Thanks for the poinetr though I am already aware of it. The equipmart does not have the equipment listed and engineers knowledgible of the whereabouts of 1 will not look into the wanted list.
Electronics Forum | Wed May 18 19:12:26 EDT 2005 | HOSS
Hello, Assuming that your dwell and coverage at the wave are in order..... Have you checked the angle and pressure of your fluxer air knife? You can only count on capilary action to a point. The air knife, set correctly, will help get your flux t