Electronics Forum | Tue Jan 22 15:54:10 EST 2008 | patrickbruneel
Stephen good observation It�s a spelling error it should be �more� instead of less. Like Dave said �[Too bad they can't afford a spell checker, eh?]� Technically correct is all equipment requiring a power source of more than 1000V AC or 1500V DC ar
Electronics Forum | Tue Jan 22 16:01:03 EST 2008 | jmelson
The P&P machine uses very modest power when idling. It draws burst of power when accelerating the gantry. So, the yearly power consumption is going to be a LOT less than nameplate figures. If it is largely air-driven, then you have to factor in th
Electronics Forum | Wed Jan 23 14:09:10 EST 2008 | lmartenson
We have carriers that we use in wave flow solderers that are machined specifically for each board out of ESD composite. I was wondering if anyone knows about lead contamination of this material and the cleaning of composite? I know that it is a p
Electronics Forum | Wed Jan 23 15:33:34 EST 2008 | vance66
I am looking to scan small 2D barcodes in-line while the circuit board is on a conveyor. Currently an operator is picking board up off the conveyor to scan them. We want something that is fixed and does not need to much manual alignment from changeo
Electronics Forum | Wed Jan 30 12:35:41 EST 2008 | patrickbruneel
I agree with Fastek. If we (the consumer) go shopping do we care more about the country of manufacturing than the pricetag? My family does but too many times they come to me and say �sorry we couldn�t find anything made in USA� only designed in USA
Electronics Forum | Wed Feb 06 15:51:26 EST 2008 | jax
We have place CSP devices with 0.105mm standoff hights without any issue. The ability to Water Wash all depends on the specifications of your wash... Spray pressure and qty of jets Dwell time, pre-wash/wash/rinse Available detergents or saponifiers
Electronics Forum | Wed Feb 06 16:05:24 EST 2008 | dphilbrick
At one point in time we were putting TI NanoStar parts on these particular boards. You don't want to attempt this at home! Thank God they took them off. Part was 1.45 X 1mm with 6 .1mm balls. They were a pain in the A$$. We had about a 90% success ra
Electronics Forum | Thu Jan 31 09:08:27 EST 2008 | glezfl36
Since the implementation of the ROHS process in our Company with the higher temp requirements, we had observed an increase in problems related to delamination in the PCB's. Actually we are using FR408 and Gracescore materials and are changing to a Ve
Electronics Forum | Fri Feb 01 11:06:07 EST 2008 | wayne123
our company has beed experiencing some delamination on our circuit boards, we have been lead free for a while and haven't been adjusting temperatures, Found out that the board house was doing something wrong in there process, finally was able to prov
Electronics Forum | Tue Mar 04 08:15:37 EST 2008 | jola
Our profile tempatures in the owen is: Preheat 6 zoones 135,155,165,175,185,195. Peak 3 zoones 255,245,240. We do check our profiles with test probs and a "Surveier" temrature recorder every 3 month and we are within the paste supplyer recommendation
