Electronics Forum | Wed Nov 16 09:46:41 EST 2005 | barryg
Has anyone dealt with a dual wave solder system. We are a bit tight in floor space and have to maintain a leaded line , but also need to convert to lead free. We are looking at dual wave systems were you have two pots to wheel into place to run one o
Electronics Forum | Thu Nov 17 09:52:41 EST 2005 | james
I agree with the one that says Fire them, but I do not have the authority to do so, but I know someone who does. I think our problem is that it is hard to find someone with SMT experience so we are stuck with what we have. Now if I was boss, trust
Electronics Forum | Mon Nov 21 11:44:43 EST 2005 | Guenther
We are running this reflow oven and are trying to get up to speed to meet RoHS. WE are having an issue with zone 9 coming up to temps. Does anyone know where we might get service or parts for this old oven? I have not found any information for this o
Electronics Forum | Mon Nov 28 11:35:37 EST 2005 | stepheniii
There is also peelable or watersoluble masking. I've only seen the peelable masking used. Not ten minutes ago an engineer showed me a board a customer was having trouble with that they are waveing all the bottom parts. That board should be selectiv
Electronics Forum | Mon Dec 19 12:23:49 EST 2005 | Amol Kane
there are no issues with running leaded lead free parts with snpb solder. the problem arises when lead-free BGAs are run with SnPb solder. running hotter (i.e mimicing the SAC reflow profile)merely ensures that the sac solder melts and mixes with the
Electronics Forum | Sun Dec 04 20:11:43 EST 2005 | mrduckmann2000
My compnay is looking for a good production AOI machine. We are looking in the $45k to $75k range. We have seen a few and feel that the Mirtec machine for $69k is a great machine. Anyone have any feelings on this machine or a machine of the same f
Electronics Forum | Tue Dec 06 06:02:47 EST 2005 | Mity-C
Good Morning, We have 4 Mirtec machines currently. We use them in our standard SMT, Lead Free and Through Hole area's. We use them for 1st pc. pre-reflow verification and 100% post reflow inspection. I recommend them highly. We have had extremely g
Electronics Forum | Tue Dec 13 07:01:56 EST 2005 | clampron
Good Morning, We are currently using 4 Mirtec machines. We decided on the Mirtec after a side by side evaluation of several tabletop machines. I have to admit that Yestech was not one of them. However, after the evaluation, the Mirtec outperformed t
Electronics Forum | Mon Dec 05 09:22:35 EST 2005 | BReiman
Does anyone know of any resources that will come into our company and provide a gap analysis between the RoHS requirements and our current processes and proceedures? We have done a lot of work so far but we want to make sure there isn't something we
Electronics Forum | Tue Dec 20 08:26:17 EST 2005 | geb
Thanks for the info. Yes the old camera was a 4mil rectangle, and the new one is a 1mil circle, 2 slots wider. The camera was calibrated on install, but they must have done something wrong, cos it doesn't realise it is 2 slots short. This screws up t
.gif)
