Electronics Forum | Wed Jan 23 11:14:11 EST 2019 | assuredtech
Do you have a spare head? or have you tried swapping the head to a different module? Is it always the same component (element)? Inspect the component under a scope / perhaps a packaging / adhesive issue. If the component is staying on the nozzle what
Electronics Forum | Sun Jan 27 17:59:25 EST 2019 | bobpan
The y-axis on that machine is left to right. If this is the axis you are having a problem with....check the motor. I have had to tighten the tension on it before. If you notice you lose steps after running for a while then this is going to be the iss
Electronics Forum | Fri Feb 01 07:07:01 EST 2019 | dfl
Another semi-related question: are the four motion cards the same? (except for the dips, I guess). I have a spare one, marked as T motion, all dips to up position. Can I use as X or Y, if I match the dips? The boards look like to have the same comp
Electronics Forum | Thu Jan 31 16:07:13 EST 2019 | dwl
Have you considered looking into using am EMS provider instead? 130k is a very small budget to set up an SMT line capable of placing and reflowing 0201's. At that price point, you will need to go with used equipment. Do you have the knowledge, time a
Electronics Forum | Wed Feb 13 13:44:03 EST 2019 | SMTA-Joe
I actually have a quote for the larger TF2800 from the rep that came to do the demo on the smaller model. There was talk of us sending hardware to PACE for them to see if they could get the larger model to work for us, but the decision was made not
Electronics Forum | Mon Feb 18 07:49:17 EST 2019 | SMTA-Joe
the tarnishing is happening across all the traces without solder even being applied. The PCB is soldered into the housing first. Once this is complete the traces have changed, and when it is time to solder the components to the traces this tarnishing
Electronics Forum | Wed Feb 20 12:40:37 EST 2019 | peramanfcs
Hi, Greetings!!! Iam a service engineer working as a free lancer. Currently iam working on a PCB where i need to replace a SMD component, i think its a transistor but iam not sure as i dont have the original schematic. I have the image with device
Electronics Forum | Fri Mar 22 13:32:15 EDT 2019 | kahrpr
all the motors on the head are the same just the connecting cable are different length. the motors have a home position for the zero pulse that home position has to match when the flag passes through the homing sensor all servos have a home position
Electronics Forum | Wed Mar 27 07:01:26 EDT 2019 | charliedci
200uM seems high. I say this because typically our solder stencils in this application are between 80uM and 100uM thick which would leave the component height less than that after reflow. However if your not experiencing any shorting between pads I w
Electronics Forum | Mon May 13 13:45:33 EDT 2019 | whitelancer64
I am having the same problem with the MPM Accela solder paste printer machine. If the fiducials are adjusted for PCB alignment, the location of the paste is then wrong, and vision inspection fails. This is a problem for both pad preview inspection