Electronics Forum | Thu May 23 18:05:07 EDT 2013 | hhaase
I'm going to be acquiring an older Kirsten Jet machine in the near future, but am having a bit of trouble locating a source for appropriate wave oil / ADL via a domestic US source. Their current recommendation is a product from Strub in Switzerlan
Electronics Forum | Fri Jul 26 13:11:06 EDT 2013 | gallionc
I think we are all on the same page with this one. Since you ran from 96 until now without any issue I'd say that now you know what causes the problem, make a note of it for next time and move on. I have found with our older machines that "if it ai
Electronics Forum | Wed Jul 03 09:13:23 EDT 2013 | dontfeedphils
I currently run the HLC software suite with a 750/760 line and another 2060 line. For the 750/760 line I have to stick with the older HLC, version 4.5 I believe, which I actually run inside of a Windows 98 virtual PC using a dongle emulator. The 20
Electronics Forum | Sat Jun 07 13:46:43 EDT 2014 | ipdisplays
Hi All, I know that is thread hasn't seen activity in a year or so... I'm having a similar issue in configuring a line. I see that the IEC addr is called version in the real.ma file. This is not helping me since I apparently have two machines that
Electronics Forum | Sun Jun 08 16:31:02 EDT 2014 | ipdisplays
Prob totally screwed the pooch... Got more than a little frustrated with not being able to get the stupid software to do what I thought it should do, anyway figured maybe the IEC port was the problem - I have a couple of spare cpu cards, so I swapped
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Fri Jan 10 00:52:46 EST 2014 | mmdashti
Dear Madam/Sir; 1)Unfortunately after some installations and commissioning SMT and THT machines from Beijing Torch (Termway) company in Iran , the quality and operation of these machines seems so so... bad in quality. Because we have some advertise
Electronics Forum | Mon Nov 04 05:22:14 EST 2013 | dselettronic
Good morning everyone I have read postings about Mirtec AOI, but they're not recent, so I'd like to know something about your experiences with Mirtec Benchtop MV-3. Our inspection department has now 3 MV-2HTL and we tried to make them as useful as po
Electronics Forum | Sat Nov 23 12:39:18 EST 2013 | joeherz
We installed a Soltec Delta 3 a few months ago and have been trying to run with a VOC free no clean. We're using SN100C in the pot. We are spraying the material and have top/bottom preheat. Evaporation of the water in the flux is a bit of a stru
Electronics Forum | Mon Nov 25 03:14:57 EST 2013 | mg2013
Hello @ the specialists, we have a Nordson Asymtek SL940 to coat our pcb's. We can use the valves SC100 and SC400 for conformal coating applications. We use the Humiseal 1A33 as the conformal coating. Now we would like to use the standard 1A33 in th