Electronics Forum | Fri May 22 11:12:25 EDT 1998 | Mike Glenn
| | Does anyone know about low pressure/low temperature | | ovens used for baking of moisture senstive | | components? | | Thanks | I need to know from where your need came. I usually just bake in conventional ovens with specified times and tempera
Electronics Forum | Tue Jun 23 11:03:15 EDT 1998 | Russ Miculich
Greg, In looking at your budget. The best place may be to contact Mancorp and see if they can outfit your needs. I believe their starter kit is about $12 to $15K for printer, p&p, and oven. This would probably be a good place to start. Just so yo
Electronics Forum | Wed May 27 22:10:25 EDT 1998 | Greg
| | I'm looking to increasing my prototyping capabilies by getting some automated pick and place equipment etc. Any leads on where to start investigating? I'm a very small job shop with 5 employees. Any help would be greatly appreciated. | Greg:
Electronics Forum | Thu May 28 12:11:34 EDT 1998 | Dave F
| | | | I'm looking to increasing my prototyping capabilies by getting some automated pick and place equipment etc. Any leads on where to start investigating? I'm a very small job shop with 5 employees. Any help would be greatly appreciated. |
Electronics Forum | Thu May 28 21:43:52 EDT 1998 | Greg
| | | | | | I'm looking to increasing my prototyping capabilies by getting some automated pick and place equipment etc. Any leads on where to start investigating? I'm a very small job shop with 5 employees. Any help would be greatly appreciated
Electronics Forum | Mon May 18 17:59:06 EDT 1998 | Richard Jackson
I've tried every thing I can think of. Do you have any Ideas? What I have is micro balls on the gold fingers of panelize boards. These balls only appear on the gold finger. Or at least I can only find them on the gold fingers. What I have tried so
Electronics Forum | Tue Jun 23 11:08:42 EDT 1998 | Russ Miculich
| Any ideas on what to buy? Only need to build surface mount protos, ability to rework. Is a rework station okay? | Will subcontract production after design is proven. Best bet is to get an Elite or OK Industries manual printer if you are not doing
Electronics Forum | Tue May 12 04:15:48 EDT 1998 | Chris Sargent
Help! We have been doing some trials on Paste Through Hole and have encountered a problem. The screen is designed (as is suggested in technical info re PTH) to give double the paste volume required to fill the void between the pin and via. The pro
Electronics Forum | Tue May 12 10:50:58 EDT 1998 | Chrys
| We are having continuous bridging problems with the trailing | leads on a 26-pin D-sub through-hole connector. The pitch is | 0.100". The connector is going through the wave at approximately | a 20 Degree angle. Does anyone have any board layout r
Electronics Forum | Fri May 08 17:12:00 EDT 1998 | Justin Medernach
| I am writing a report about screen printing. | Does anyone know where I can find information about | screen printing and screen printing machines? Pete, Try www.dek.com and www.mpmcorp.com These guys are the biggest automatic printer mfrs. in th