Electronics Forum | Thu Aug 20 02:14:16 EDT 2015 | armandogomez
Hello ! I am looking for a manufacturer for a eccentric screw pump, we have a Bartec equipment but that machine is pricey and we are looking for a low budget for some prototypes we have to do, and they have a epoxy encapsulation. Thanks
Electronics Forum | Thu Aug 20 12:38:29 EDT 2015 | wjongenelen
My company is looking for rework support to handle design prototype needs. Any suggestions would be appreciated. Thanks Will
Electronics Forum | Thu Aug 20 13:04:57 EDT 2015 | dyoungquist
Try Axiom Electronics in Beaverton. They do BGA X-ray and BGA rework/replacement for us. I don't know what your exact needs are but give them a try. www.axiomsmt.com
Electronics Forum | Wed Aug 26 09:14:04 EDT 2015 | rgduval
Hey, Will, Check out my company: http://www.macrofab.net. We aren't in Portland...we're down in Houston....but, we ship world-wide. We were founded specifically to enable prototyping! cheers, ..rob
Electronics Forum | Fri Aug 21 09:36:50 EDT 2015 | esoderberg
Looking for better design information than is contained in IPC 7525A. Specifically the minimum trough width and length of the step to achieve the necessary paste reduction.
Electronics Forum | Thu Aug 27 16:44:11 EDT 2015 | esoderberg
I have that article. While some of the information is helpful, there is no direction as to the length and width of the step to achieve blade deflection to reduce paste.
Electronics Forum | Fri Aug 28 12:11:10 EDT 2015 | davef
LED: [Light-emitting diode] https://en.wikipedia.org/wiki/Light-emitting_diode Neon lamp: https://en.wikipedia.org/wiki/Neon_lamp
Electronics Forum | Sat Aug 22 09:59:44 EDT 2015 | linux
Hello all, Can someone tell me the step by step procedure to check xo,yo, mark read position using Fuji board. Cp6 Fuji.
Electronics Forum | Sat Aug 29 21:45:49 EDT 2015 | sarason
And I might add the immortal words of Lord Kelvin "To measure, is to know" and again reiterated by Deming in a slightly more acidic way "In God we trust, All others must bring data" sarason
Electronics Forum | Thu Oct 01 12:46:57 EDT 2015 | gregoryyork
Would be nice to see your profile, as I would imagine you could be too cool in reflow especially if seeing milky residues in Paste could be Organics that havent volatised out properly
winsouce.jpg)
