Electronics Forum | Tue Jul 02 14:34:07 EDT 2019 | samdee21
Does anyone have the software to make these machines run... My hard disk has become corrupted and unable to boot from it. Please email me at samdee21 @gmail.com
Electronics Forum | Fri Jan 17 05:53:09 EST 2020 | eddas
I have the same problem. Did You get hard disk copy or some info what to do in such situation?
Electronics Forum | Fri Jan 17 06:59:26 EST 2020 | eddas
I wrote to TWS support few days ago, but no answer. How much did You paid and was it dificult to write everything to HDD?
Electronics Forum | Sun Jan 19 04:50:59 EST 2020 | samdee21
I found my hard disk was ok.. the software I paid £50 I documented everything at http://tws-quadra.co.uk/ Drop me an email at samdee21@gmail.com
Electronics Forum | Tue Jul 02 15:13:13 EDT 2019 | daniel_marquette
On our QSP-2, the Y axis belts start to vibrate during the process so we need to open the doors to stop this because of the humming sound. What can creates this knowing that all the movements and placement are spot on?
Electronics Forum | Wed Jul 03 07:49:35 EDT 2019 | daniel_marquette
Got it. Servo tuning is new to us, so we'll try it. When you propose to swap the Y axis amps, do you refer to the driver that controls the Y motors? Thanks,
Electronics Forum | Tue Jul 02 15:20:16 EDT 2019 | daniel_marquette
Hi, any idea what can cause 5% intermittent right component lead being bent during CTA transfer to the forks? Yet, everything is line up on these 2.5 mm lead span components.
Electronics Forum | Tue Jul 09 06:11:15 EDT 2019 | alpha1
I would check the clearance between the bottom guide and the carrier clip. Usually I set it .004 below the clop then set the head height .004 above the guide. It's a little tighter than UIC specs but it'll prevent the lead better.
Electronics Forum | Tue Jul 09 13:56:30 EDT 2019 | daniel_marquette
Yeah, I struggled at stabilizing it so for now it's ok. It's the only machine on it's air line.
Electronics Forum | Mon Jul 22 09:54:57 EDT 2019 | daniel_marquette
Had to adjust more finely the timing on the soft push and the down stroke for insertion. I added flow controls on both input of the respectives cylinders with enough success to start production. This way, the soft push is late enough not to screw the
winsouce.jpg)