Electronics Forum | Sun Sep 30 07:39:00 EDT 2012 | saduquette
Hi bobpan, Just wanted to follow up on my problem. With a bit of reverse engineering, I was able to troubleshhot my board to a faulty trace between the EEPROM and DSP chip. Since it was an 'inner layer' trace I had no choice but to 'green wire' i
Electronics Forum | Wed Sep 26 15:16:29 EDT 2012 | hegemon
Pads look WAY oversize for the LED leads. Perhaps the solder won't go to the LED because it is spreading across the pads on the PCB instead. The board pad vs. component lead size equation I see would make me expect some starvation of the joints at t
Electronics Forum | Wed Sep 26 14:18:50 EDT 2012 | tank
Wondering how good the software is for the Quad QSA 30 is. Is it a pain to program? We have panels with 100 boards... 1500 parts, I hope you don't have to manually teach the whole panelized board. Any other info you can provide is welcome. We
Electronics Forum | Wed Sep 26 15:04:09 EDT 2012 | kahrpr
The QSA30 is basically a Samsung CP40 with a few changes. For an older machine the programming is pretty good. it can do array boards and has an import feature for XY data. Tts been about 7 years since I ran one. Its a pretty solid machine.
Electronics Forum | Thu Sep 27 05:47:21 EDT 2012 | bobpan
Check the software version before you buy it. If it is not version 6.75 do not buy it. This is the last version released for this machine and fixes many bugs that made running a panelized board a nightmare. 0603 parts and above is where i would stay
Electronics Forum | Tue Oct 02 10:30:10 EDT 2012 | eniac
Difference in pick height from paper and embossed reel (typically) is 0.2 mm. Try to change your pick height and place height (different type of capacitors have a different height: for 100 nF 0603 and for 4.7 uF 0603 it's a big difference!). Can you
Electronics Forum | Sun Dec 09 11:58:34 EST 2012 | ericrr
Is BOC, Beginning Of Cycle? If it is how boring, The real root of the problem is, some of the parts are not put on the correct place, some of the misplaced parts wobble over on the bubble of solder going through the oven, but some been so light st
Electronics Forum | Fri Dec 21 16:34:28 EST 2012 | bdamico
Hello All, Some of the issues reported in this thread sound similar to those commonly experienced with network delays. A very simple way to determine if this is indeed the case is to run directly off of the system hard drive versus a network hard d
Electronics Forum | Tue Apr 23 02:28:24 EDT 2013 | padawanlinuxero
I will go with Hegemon and Swag, our mirtec has those delays too, our system run locally, and when the hard drive gets full it crash, so we had to install a second hard drive of 1TB and save all pictures there like a backup we run it every weekend, n
Electronics Forum | Thu Apr 25 13:55:36 EDT 2013 | bdamico
Hello Eadthem, This is very disturbing information. I urge you to contact our technical support center so that we may assist you in resolving these issues. Our contact information is available at http://www.mirtecusa.com. As stated earier, plea