Electronics Forum | Wed May 19 09:32:28 EDT 2004 | Mr Fix it - MPM
Sounds to me like the driver for the tactile is not working. The tactile has three components to it. The first is the switch, the second is the pneumatic up/down actuator and the third is a small motor in the tactile assembly. The motor has a driv
Electronics Forum | Tue Apr 27 16:49:16 EDT 2004 | davef
Where blank are the balls on a BGA supposed be? UNDERNEITH, dammit!!! Fire that inspector. It's good that you have your balls imbedded in something, so that they are not rolling around. Beyond that, consider the five ball system! - No more than
Electronics Forum | Wed Apr 28 10:32:19 EDT 2004 | vickt
This was not a automatic feature of the 4796 series HSPs. You can try to continue to reset-start the feeder crg after each component missing event,and slowly build the remaining placements, but at some point you will reach a dead end. My best advice
Electronics Forum | Wed Apr 28 09:43:22 EDT 2004 | Rob
When it comes to double-sided boards, how does one support a board so that those supports don't hit any components on the side already run but yet keep the board firm and rigid? Is it more of an engineering design to layout the board in such a way th
Electronics Forum | Wed Apr 28 12:16:09 EDT 2004 | paul_bmc
We usually make a template offline to put with the assembly file. When it is time to run, place the pin support template in the machine, place your pins and your ready to go. Probably about a 15 sec setup. We looked into the ready-e-set pin suppor
Electronics Forum | Wed Apr 28 13:33:48 EDT 2004 | Rob
Thanks to all. The way I've been doing it has been crude and very similar to your method. I make an imprint of the bottom side and cut out areas where components sit and this imprint transfers over to a cardboard. When it comes time to run the second
Electronics Forum | Thu Apr 29 04:34:07 EDT 2004 | allsmt
Dear Sir's, we had become an inquiry from an customer of allSMT, who is in need of an Machine which can solder via Laser? does anybody has experience with this procedure? I will try to explain the project. The pcb is an Aluminium pcb. There must
Electronics Forum | Thu Jun 03 18:10:28 EDT 2004 | g2garyg2
It sounds like you will need to pre-heat the aluminum beofre using even a laser to solder this type of application. While lasers are great for many applications, especially those that have challenging keep out areas, thermal mass issues (with approp
Electronics Forum | Thu May 06 06:28:08 EDT 2004 | mskler
This all the things depends upon your requirement. Can you please answer the following things 1.How may components in one board. 2.How many types of components also tell the packages also if you know. 3.What quantity per month/Year you want to produ
Electronics Forum | Thu May 06 06:28:16 EDT 2004 | mskler
This all the things depends upon your requirement. Can you please answer the following things 1.How may components in one board. 2.How many types of components also tell the packages also if you know. 3.What quantity per month/Year you want to produ