Electronics Forum | Fri Apr 05 02:05:33 EDT 2024 | ddfreeze
also swapped out DRAM sticks
Electronics Forum | Mon Apr 08 08:20:09 EDT 2024 | micropak
Can you try using a different set of DRAM sticks ?
Electronics Forum | Thu Jul 20 10:48:43 EDT 2006 | pms
Ev, This error could be caused by any number of problems. Is there an error message in the message window before hardware initiation error? If so, what is it? A failure in any axis (x,y,z,c,theta,y-wagon,tray-wagon) could cause your symptom. Paul
Electronics Forum | Thu Jul 31 03:20:29 EDT 2008 | miroyu
Hi everyone I have Quad 4C with following problem. When I run machine "cold start" first power up it will run and initialize but after if I turn it off and back on it will NOT initialize. Z axis will push nozzle down and it will remain i that posit
Electronics Forum | Wed Jul 24 15:33:49 EDT 2019 | weglimir
Hello, We've got this DEK256GSX quite some time ago, and finally we've managed to start and initialize it. However the problem is that we don't know edit password, and re-seller that we initially bought this unit from doesn't know the password as w
Electronics Forum | Mon Mar 01 22:51:05 EST 2021 | rob1
We have a DEK 265 Horizon and it exhibits a problem with conveyor belts. When I power up the DEK and try to paste boards, it fails to initialize the conveyor. I have to go into Maintenance and select cycle boards on rails. This too fails, but when I
Electronics Forum | Mon Jun 21 15:42:26 EDT 2021 | pjchonis
Hello everyone, I would love to learn about your thought processes when initially choosing chemistry to be approved in your production lines? What were the pros and cons? Are you still satisfied with your decision? Would you choose a different chem
Electronics Forum | Thu Dec 30 20:48:09 EST 2021 | openindus
We acquired the machine few weeks ago and it was working fine until the printer won't initialize anymore with "USC park failed" error. It seems that the printer won't respond to "4 MAXY_SP 61,0" message. Is someone has already en
Electronics Forum | Mon Apr 18 12:06:03 EDT 2022 | dsmith
During the initialization process, the table will make small movements up and down, and occasionally go all the way up and back down again, then continue to bounce up and down maybe an inch of travel, it never completes initializing. I wasn't operati
Electronics Forum | Thu Apr 28 03:58:52 EDT 2022 | erici
We are having problems with our Siemens Siplace S27 machine. The machine is giving the error - Y-axis Faulty initialization of Motor. We replaced the Y motor card and swapped also the servo control cards on the two gantries. Still will not initiali