Electronics Forum | Mon Aug 10 16:53:26 EDT 2015 | rgduval
If the pendulum is motor driven, it's more likely that a capacitor change will accomplish what you want than a resistor change. You've got a 47uF in there...try a factor of 10, and put a 4.7uF in there and see what happens. If the pendulum period i
Electronics Forum | Sat Sep 26 00:53:54 EDT 2015 | padawanlinuxero
Hi guys, > > Recently got an error message when > initiating hardware on a Mydata TP9-UFP. Message > is: Theta/2: Lower end point not repeatable. > Reinitiating fails at message. Haven't seen this > message before. Any idea what it could be as
Electronics Forum | Mon Feb 01 04:57:08 EST 2016 | oxygensmd
If you can use the standalone mode then choose the program on "option" and somewhere you can load program - "aktuell". The "aktuell" program is the last program what was downloaded on this machine. In SiTest you can test and calibrate the machine. Y
Electronics Forum | Wed Apr 20 13:13:20 EDT 2016 | ttheis
Hi Guys, Yesterday one of our two gsm1 machines just stopped moving and let down the board mid-production. The epc computer continued to respond but no messages were displayed when palming up or down. I tried local IO and it said no IO was configure
Electronics Forum | Thu Jun 02 22:40:13 EDT 2016 | slouis2014
Hi, yes have a few experiments initially i tried to increase the solder volume but component pin have insufficient solder. 1. The solder coverage do you calculate it by solder volume or solder area. 2. if i would achieve as you recommend 50-60 % woul
Electronics Forum | Wed Sep 07 16:36:18 EDT 2016 | ttheis
It does look like it was setup for fuji or siemens connection. I did get the smema signals working; had to add the connections for pins 3 & 4 on both ports and move some of the existing connections according to the smema diagram. Also, I wasn't seein
Electronics Forum | Sun Nov 27 16:53:39 EST 2016 | ttheis
Our UP500 has been running great for a few months then the AC/DC 5/12/24V power supply stopped working and the PC could not communicate with the cage. The PC screen also got very noisy. We replaced the power supply with a used replacement and the ma
Electronics Forum | Tue Nov 29 11:45:35 EST 2016 | ttheis
I was able to repair the original power supply for the printer again with parts from another similar power supply on ebay. At first the machine didn't power up properly even though the supply voltages were all good on a volt meter when tested befor
Electronics Forum | Wed Nov 30 20:43:06 EST 2016 | ttheis
OK, so went to power up again today and had the same kind of issues. The 24V and 5V lights on the cage flicker dimly about every 500ms. I tried my trick of disconnecting the +24v lead to the lift table amp and it acted the same, so it didn't work th
Electronics Forum | Tue Dec 27 09:39:36 EST 2016 | westshoredesign
Thank you for the reply, MPMEng. I received the Speedline UPG-026/27, but it actually came with the incorrect mouse. Since original post I've contacted seller, received correct mouse, successfully installed drivers, encountered a new issue. At thi